DI10 datasheet(179/416 Pages) MICROCHIP

179 / 416 page

 2016-2018 Microchip Technology Inc.

DS30010118D-page 179

PIC24FJ256GA705 FAMILY

bit 3

TRIGMODE: Trigger Status Mode Select bit

1 = TRIGSTAT (OCxCON2<6>) is cleared when OCxRS = OCxTMR or in software

0 = TRIGSTAT is only cleared by software

bit 2-0

OCM<2:0>: Output Compare x Mode Select bits(1)

111 = Center-Aligned PWM mode on OCx(2)

110 = Edge-Aligned PWM mode on OCx(2)

101 = Double Compare Continuous Pulse mode: Initializes the OCx pin low; toggles the OCx state

continuously on alternate matches of OCxR and OCxRS

100 = Double Compare Single-Shot mode: Initializes the OCx pin low; toggles the OCx state on

matches of OCxR and OCxRS for one cycle

011 = Single Compare Continuous Pulse mode: Compare events continuously toggle the OCx pin

010 = Single Compare Single-Shot mode: Initializes OCx pin high; compare event forces the OCx pin low

001 = Single Compare Single-Shot mode: Initializes OCx pin low; compare event forces the OCx pin high

000 = Output compare channel is disabled

OCxCON1: OUTPUT COMPARE x CONTROL REGISTER 1 (CONTINUED)

Note 1:

The OCx output must also be configured to an available RPn pin. For more information, see Section 11.5

“Peripheral Pin Select (PPS)”.

The Fault input enable and Fault status bits are valid when OCM<2:0> = 111 or 110.

The Comparator 1 output controls the OC1-OC3 channels.

The OCFA/OCFB Fault input must also be configured to an available RPn/RPIn pin. For more information,

see Section 11.5 “Peripheral Pin Select (PPS)”.

DI10 Datasheet(PDF) 179 Page - Microchip Technology