HD6432142 datasheet(711/1177 Pages) RENESAS

711 / 1177 page

Section 22 ROM (Mask ROM Version, H8S/2148 F-ZTAT, H8S/2147N F-ZTAT, H8S/2144 F-ZTAT, and H8S/2142 F-ZTAT)

Rev. 4.00 Sep 27, 2006 page 667 of 1130

REJ09B0327-0400

22.8

Flash Memory Protection

There are three kinds of flash memory program/erase protection: hardware protection, software

protection, and error protection.

22.8.1

Hardware Protection

Hardware protection refers to a state in which programming/erasing of flash memory is forcibly

disabled or aborted. Hardware protection is reset by settings in flash memory control registers 1

and 2 (FLMCR1, FLMCR2) and erase block registers 1 and 2 (EBR1, EBR2). (See table 22.8.)

Table 22.8

Hardware Protection

Functions

Item

Description

Program

Erase

Reset/standby

protection

• In a reset (including a WDT overflow reset),

software standby mode, subactive mode,

subsleep mode, and watch mode, FLMCR1,

FLMCR2, EBR1, and EBR2 are initialized,

and the program/erase-protected state is

entered.

• In a reset via the RES pin, the reset state is

not entered unless the

RES pin is held low

until oscillation stabilizes after powering on. In

the case of a reset during operation, hold the

RES pin low for the RES pulse width specified

in the AC Characteristics section.

Yes

22.8.2

Software Protection

Software protection can be implemented by setting the SWE bit in FLMCR1 and erase block

registers 1 and 2 (EBR1, EBR2). When software protection is in effect, setting the P or E bit in

flash memory control register 1 (FLMCR1) does not cause a transition to program mode or erase

mode. (See table 22.9.)

HD6432142 Datasheet(PDF) 711 Page - Renesas Technology Corp