ST7LITE29F2 datasheet(152/166 Pages) STMICROELECTRONICS

152 / 166 page

Device configuration

ST7LITE20F2 ST7LITE25F2 ST7LITE29F2

152/166

Doc ID 8349 Rev 5

15.1.2

Option byte 1

●

OPT7 =

PLLx4x8 PLL Factor selection.

0: PLLx4

1: PLLx8

●

OPT6 =

PLLOFF PLL disable

0: PLL enabled

1: PLL disabled (by-passed)

●

OPT5 =

PLL32OFF 32MHz PLL disable

0: PLL32 enabled

1: PLL32 disabled (by-passed)

●

OPT4 =

OSC RC Oscillator selection

0: RC oscillator on

1: RC oscillator off

Note:

1% RC oscillator available on ST7LITE25 and ST7LITE29 devices only

If the RC oscillator is selected, then to improve clock stability and frequency accuracy, it is

recommended to place a decoupling capacitor, typically 100nF, between the VDD and VSS

pins as close as possible to the ST7 device.

●

OPT3:2 =

LVD[1:0] Low voltage detection selection

These option bits enable the LVD block with a selected threshold as shown in Table 95.

●

OPT1 =

WDG SW Hardware or Software Watchdog

This option bit selects the watchdog type.

0: Hardware (watchdog always enabled)

1: Software (watchdog to be enabled by software)

●

OPT0 =

WDG HALT Watchdog Reset on HALT

This option bit determines if a RESET is generated when entering HALT mode while

the Watchdog is active.

0: No Reset generation when entering HALT mode

1: Reset generation when entering HALT mode

Table 95.

LVD Threshold Configuration

Configuration

LVD1

LVD0

LVD Off

Highest Voltage Threshold (

∼4.1V)

Medium Voltage Threshold (

∼3.5V)

Lowest Voltage Threshold (

∼2.8V)

ST7LITE29F2 Datasheet(PDF) 152 Page - STMicroelectronics

ST7LITE29F2 Datasheet(HTML) 152 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL