ST72F262G2B5 datasheet(95/172 Pages) STMICROELECTRONICS

Part #	ST72F262G2B5

Description	8-BIT MCU WITH FLASH OR ROM MEMORY, ADC, TWO 16-BIT TIMERS, I2C, SPI, SCI INTERFACES

Download	172 Pages

Scroll/Zoom	100%

Manufacturer	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

95 / 172 page

ST72260Gx, ST72262Gx, ST72264Gx

95/172

SERIAL COMMUNICATIONS INTERFACE (Cont’d)

11.5.4.9 Clock Deviation Causes

The causes which contribute to the total deviation

are:

–DTRA: Deviation due to transmitter error (Local

oscillator error of the transmitter or the trans-

mitter is transmitting at a different baud rate).

–DQUANT: Error due to the baud rate quantisa-

tion of the receiver.

–DREC: Deviation of the local oscillator of the

receiver: This deviation can occur during the

reception of one complete SCI message as-

suming that the deviation has been compen-

sated at the beginning of the message.

–DTCL: Deviation due to the transmission line

(generally due to the transceivers)

All the deviations of the system should be added

and compared to the SCI clock tolerance:

DTRA + DQUANT + DREC + DTCL < 3.75%

11.5.4.10 Noise Error Causes

See also description of Noise error in Section

11.5.4.3.

Start bit

The noise flag (NF) is set during start bit reception

if one of the following conditions occurs:

1. A valid falling edge is not detected. A falling

edge is considered to be valid if the 3 consecu-

tive samples before the falling edge occurs are

detected as '1' and, after the falling edge

occurs, during the sampling of the 16 samples,

if one of the samples numbered 3, 5 or 7 is

detected as a “1”.

2. During sampling of the 16 samples, if one of the

samples numbered 8, 9 or 10 is detected as a

“1”.

Therefore, a valid Start Bit must satisfy both the

above conditions to prevent the Noise Flag getting

set.

Data Bits

The noise flag (NF) is set during normal data bit re-

ception if the following condition occurs:

– During the sampling of 16 samples, if all three

samples numbered 8, 9 and10 are not the same.

The majority of the 8th, 9th and 10th samples is

considered as the bit value.

Therefore, a valid Data Bit must have samples 8, 9

and 10 at the same value to prevent the Noise

Flag getting set.

Figure 56. Bit Sampling in Reception Mode

RDI LINE

Sample

clock

12345678910

11

12

13

14

15

16

sampled values

One bit time

6/16

7/16

Similar Part No. - ST72F262G2B5

Manufacturer	Part #	Datasheet	Description
STMicroelectronics	ST72F262G2B6	2Mb / 171P	8-BIT MCU WITH FLASH OR ROM MEMORY, ADC, TWO 16-BIT TIMERS, I2C, SPI, SCI INTERFACES August 2003 Rev. 1.7
STMicroelectronics	ST72F262G2B6	1Mb / 172P	8-BIT MCU WITH FLASH OR ROM MEMORY, ADC, TWO 16-BIT TIMERS, I2C, SPI, SCI INTERFACES

More results

Similar Description - ST72F262G2B5

Manufacturer	Part #	Datasheet	Description
STMicroelectronics	ST72260G	2Mb / 171P	8-BIT MCU WITH FLASH OR ROM MEMORY, ADC, TWO 16-BIT TIMERS, I2C, SPI, SCI INTERFACES August 2003 Rev. 1.7
	ST72260GX	1Mb / 172P	8-BIT MCU WITH FLASH OR ROM MEMORY, ADC, TWO 16-BIT TIMERS, I2C, SPI, SCI INTERFACES
	ST72334J	1Mb / 153P	8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, ADC, 16-BIT TIMERS, SPI, SCI INTERFACES
	ST72334J	1,022Kb / 125P	8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, ADC, 16-BIT TIMERS, SPI, SCI INTERFACES
	ST72334XX-AUTO	3Mb / 150P	8-bit MCU for automotive with single voltage Flash/ROM memory, ADC, 16-bit timers, SPI, SCI interfaces
	ST72340	3Mb / 191P	8-BIT MCU WITH UP TO 16K FLASH MEMORY, 10-BIT ADC, TWO 16-BIT TIMERS, TWO I2C, SPI, SCI
	ST72104G	909Kb / 135P	8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, ADC, 16-BIT TIMERS, SPI, I2C INTERFACES February 2000 Rev. 2.2
	ST72104GX-AUTO	3Mb / 135P	8-bit MCU for automotive with single voltage Flash/ROM memory, ADC, 16-bit timers, SPI, I2C interfaces
	ST72325	3Mb / 196P	8-bit MCU with 16 to 60K Flash/ROM, ADC, CSS, 5 timers, SPI, SCI, I2C interface
	ST7232A	1Mb / 154P	8-BIT MCU WITH 8K FLASH/ROM, ADC, 4 TIMERS, SPI, SCI INTERFACE

More results

ST72F262G2B5 Datasheet(PDF) 95 Page - STMicroelectronics

ST72F262G2B5 Datasheet(HTML) 95 Page - STMicroelectronics

Similar Part No. - ST72F262G2B5

Similar Description - ST72F262G2B5

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL