| Electronic Components Datasheet Search |
|
ST7LITEUS2 Datasheet(PDF) 123 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
ST7LITEUS2 Datasheet(HTML) 123 Page - STMicroelectronics |
|
123 / 136 page ![]() Obsolete Product(s) - Obsolete Product(s) Obsolete Product(s) - Obsolete Product(s) ST7LITEUS2, ST7LITEUS5 Device configuration and ordering information 123/136 14 Device configuration and ordering information Each device is available for production in user programmable versions (FLASH) as well as in factory coded versions (FASTROM). Refer to Table 79 for the full list of supported part numbers: ● ST7FLITEUSA2xx and ST7FLITEUSA5xx XFlash devices are shipped to customers with a default program memory content (FFh). ● Factory Advanced Service Technique ROM (FASTROM) versions are also available: they are factory-programmed XFlash devices. The FASTROM factory coded parts contain the code supplied by the customer. This implies that FLASH devices have to be configured by the customer using the Option Bytes while the FASTROM devices are factory-configured. 14.1 Option bytes The two option bytes allow the hardware configuration of the microcontroller to be selected. The option bytes can be accessed only in programming mode (for example using a standard ST7 programming tool). 14.1.1 OPTION BYTE 1 Bit 7:6 CKSEL[1:0] Startup clock selection. This bit is used to select the startup frequency. By default, the internal RC is selected (see Table 75: Startup clock selection). Bit 5 Reserved, must always be 1. Bit 4 Reserved, must always be 0. Bits 3:2 LVD[1:0] Low Voltage Detection selection These option bits enable the LVD block with a selected threshold as shown in Table 76: LVD threshold configuration. Bit 1 WDG SW Hardware or software watchdog This option bit selects the watchdog type. 0: Hardware (watchdog always enabled) 1: Software (watchdog to be enabled by software) Bit 0 WDG HALT Watchdog Reset on Halt This option bit determines if a reset is generated when entering Halt mode while the watchdog is active. 0: No Reset generation when entering Halt mode 1: Reset generation when entering Halt mode Obsolete Product(s) - Obsolete Product(s) |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |