SLEV900AFB datasheet(4/16 Pages) PHILIPS

4 / 16 page

2002 May 23

Philips Semiconductors

Product speciﬁcation

I-CODE Evaluation kit

SLEV900

BLOCK DIAGRAM

handbook, full pagewidth

MGW407

EXTERNAL

I-CODE READER

SLRM900

I-CODE

ANTENNA

antenna

cable

I-CODE

labels

3 disks

2 manuals

I-CODE

inlets

power supply

cable DC

serial

interface

cable

EXTERNAL

POWER

SUPPLY

Fig.1 Block diagram.

FUNCTIONAL DESCRIPTION

6.1

Hardware

Getting started with the I-CODE evaluation kit requires the

following steps:

1. Connect the antenna cable to the BNC connector at

the I-CODE reader

2. Connect the serial interface cable to the COM1 or

COM2 port at your host PC and to the connector at the

I-CODE reader

3. Connect the 24 V power supply cable to the

appropriate connector at the I-CODE reader and to a

±1 V, 40 W power supply

4. Connect the 24 V power supply to the mains and

switch it on.

The I-CODE reader is now ready for use.

Remark: The I-CODE evaluation kit is delivered with an

RF power output of 4 W. Since the evaluation kit antenna

was designed for that output power level, an RF power

higher than 4 W might damage the evaluation kit antenna

If higher RF power is desired a customized antenna has to

be used (e.g. gate antennas).

The RF power output is adjustable by software (e.g. with

CRMTEST3.EXE).

6.2

Software

6.2.1

SYSTEM REQUIREMENTS

Minimum requirements of external PC:

• Pentium 133 MHz; 32 Mb RAM

• UART 16 550A (or compatible)

• 5 Mb free disk space

• Floppy disk drive 3.5 inch

• Resolution of the video-card and monitor:

– 800

× 600 with small fonts or

– 1024

× 768 with large fonts.

• Colour depth:

– 16-bit (65536).

SLEV900AFB Datasheet(PDF) 4 Page - NXP Semiconductors

SLEV900AFB Datasheet(HTML) 4 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Datasheet Download

Link URL