LT1806 datasheet(19/26 Pages) LINER

19 / 26 page

LTC2323-16

232316fc

For more information www.linear.com/LTC2323-16

APPLICATIONS INFORMATION

Total Harmonic Distortion (THD)

Total harmonic distortion (THD) is the ratio of the

RMS sum of all harmonics of the input signal to the

fundamental itself. The out-of-band harmonics alias into

the frequency band between DC and half the sampling

frequency (fSMPL/2). THD is expressed as:

THD

=20log

V22

+ V32 + V42 +…+ VN2

where V1 is the RMS amplitude of the fundamental

frequency and V2 through VN are the amplitudes of the

second through Nth harmonics.

POWER CONSIDERATIONS

The LTC2323-16 requires two power supplies: the 5V

power supply (VDD), and the digital input/output interface

power supply (OVDD). The flexible OVDD supply allows

the LTC2323-16 to communicate with any digital logic

operating between 1.8V and 2.5V. When using LVDS I/O,

the OVDD supply must be set to 2.5V.

Power Supply Sequencing

The LTC2323-16 does not have any specific power sup-

ply sequencing requirements. Care should be taken to

adhere to the maximum voltage relationships described

in the Absolute Maximum Ratings section. The LTC2323-

16 has a power-on-reset (POR) circuit that will reset the

LTC2323-16 at initial power-up or whenever the power

supply voltage drops below 2V. Once the supply voltage

re-enters the nominal supply voltage range, the POR will

reinitialize the ADC. No conversions should be initiated

until 10ms after a POR event to ensure the reinitialization

period has ended. Any conversions initiated before this

time will produce invalid results.

Figure 17. Power Supply Current of the LTC2323-16 Versus Sampling Rate

SAMPLE FREQUENCY (Msps)

232316 F17

LT1806 Datasheet(PDF) 19 Page - Linear Technology