CDM Cornell Dubilier • 140 Technology Place • Liberty, SC 29657 • Phone: (864)843-2277 • Fax: (864)843-3800

Type MLSH 125 °C Hermetic Slimpack, Aluminum Electrolytic Capacitor

Vibration Test

Level

The specimens, while deenergized or operating under the load conditions

specified, shall be subjected to the vibration amplitude, frequency range,

and duration specified for each case size.

Amplitude

The specimens shall be subjected to a simple harmonic motion having an

amplitude of either 0.06-inch double amplitude (maximum total excursion)

or peak level specified above, whichever is less. The tolerance on vibration

amplitude shall be ±10 percent.

Frequency Range

The vibration frequency shall be varied logarithmically between the

approximate limits of 10 to 2,000 Hz.

Sweep Time and Duration

The entire frequency range of 10 to 2,000 Hz and return to 10 Hz shall be

traversed in 20 minutes. This cycle shall be performed 12 times in each

of three mutually perpendicular directions (total of 36 times), so that

the motion shall be applied for a total period of approximately 12 hours.

Interruptions are permitted provided the requirements for rate of change

and test duration are met.

High Reliability Test/Burn-in

Established Reliability capacitors shall be subjected to a minimum of 100

percent of the DC rated voltage at 85 ºC for 48 hours minimum but not to

exceed 96 hours. During this test, capacitors shall be adequately protected

against temporary voltage surges of 10 percent or more of the test voltage.

After burn-in, the capacitors shall be returned to room ambient conditions

and the DC leakage, capacitance, and ESR shall be measured with respect

to specified limits.

Thermal Resistance

Typical Weight

Case JK - 32g

Terminals

18 AWG copper wire with 60/40 tin-lead electroplate, 20 amps max

Case Material

Stainless Steel

Ripple Current Capability

The ripple current capability is set by the maximum permissible internal

core temperature, 125 ºC.

Air Cooled

The ripple currents in the ratings tables are for 85 ºC case temperatures.

For air temperatures without a heatsink use the multipliers for Ambient

Temperature, No Heatsink.

Heatsink Cooled

Temperature rise from the hottest internal spot, the core, to ambient air is

where θcc is the thermal resistance from core to case and θca from case to

ambient. To calculate maximum ripple capability with the MLSH attached to

a heatsink use the maximum core temperature and the values for θcc.

Example

As an illustration, suppose you operate an noninsulated

MLSH172M050JK0C in 95 ºC air and attach it to a commercial heatsink

with a free-air thermal resistance of 2.7 ºC/W. Use a good thermal grease

between the MLSH and the heatsink, and the total thermal resistance is 2.7

+6. 6 or 9.3º C/W. The power which would heat the core to 125 °C is (125 -

95)/9. 3 or 3.2 W. For an ESR of 108 mΩ, 3.2 W equates to a ripple current of

5.45 A.

Large Sides

Heatsinked

Case Length

1.5"

Insulation

ºC/W

one

None

6.6

Polyester

7.2

both

None

4.4

Polyester

4.7