8765 datasheet(2/4 Pages) ETC

2 / 4 page

Cutting: Die-cutting is recommended, although it

can also be hand-cut or guillotined.

Screen Printing (After lamination): 3M™ Scotchlite™

Reflective Material - 8765 White Transfer Film offers

good screen print adhesion. Choice of ink will depend

on application and care instructions.

Sublimation Printing (After lamination):

Scotchlite reflective material - 8765 white transfer

film offers good ink adhesion and durability for

sublimated colors and images. Recommended

contact for sublimation information is Holt Mfg.

(919) 227-5561. For further information contact

your local 3M Technical Service representative.

Heat Lamination: Work on a flat surface where

uniform heat and pressure can be applied. Avoid

applying film over seams and stitches.

1. Remove plastic liner, exposing dry adhesive. Do

not remove paper liner.

2. Place Scotchlite reflective material - 8765 white

transfer film on fabric (substrate) adhesive side

down and apply heat and pressure as described

below. Place a non-stick slip sheet between the

platen and laminating surface to prevent any

excess adhesive transfer contamination.

3. Allow application to cool (room temperature)

before removing the paper liner. Place application

on a flat surface and remove the paper liner by

lifting one corner and pulling (about 45˚ angle) in

a continuous, smooth manner.

Note: Do not exceed lamination temperatures of

375˚F (190˚C) because the paper liner may become

difficult to remove. If high temperatures are required

for bond durability, follow lamination steps 1-3, and

then relaminate at the higher temperature (use a non-

stick slip sheet to protect the application).

The following recommendation is a general guideline for

heat press lamination. Other lamination methods such as

roll to roll, heat fusing, and High Frequency (HF) welding

can also be used. The proper temperature/pressure/time

conditions must be tested for each fabric to assure

adequate adhesion. Many fabrics can be used as

lamination substrates, however, nylons and fabrics treated

with a durable water repellent (DWR) finish are difficult

to adhere to and are not recommended.

Care and Maintenance Instructions

Important: Test each application according to

appropriate care instructions required for the finished

product. Actual life of Scotchlite reflective material -

8765 white transfer film depends on cleaning method

and wear conditions.

Wash: Machine wash warm, 40˚C (105˚F)

Bleach: Only non-chlorine bleach when needed

Dry: Tumble dry low

Iron: Use cool iron, 150˚C (300˚F)

Dryclean: Dryclean, normal cycle

Temperature

Dwell Time

Pressure

325-375˚F

10-20 seconds

Firm

(165-190˚C)

(30-40 psi

line pressure)

8765 Datasheet(PDF) 2 Page - List of Unclassifed Manufacturers

8765 Datasheet(HTML) 2 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4

Datasheet Download

Link URL