Io=3A non-isorated step-down DC/DC Converter module

MPM00 Series

SANKEN ELECTRIC CO., LTD.

Sep./15/2015

Rev.3.0

13

http://www.sanken-ele.co.jp

 Soldering should be at a distance of at least 1.5 mm from the body of the products.

When soldering the products, please be sure to minimize the working time, within the following limits:

・Reflow

Preheat ; 180 °C / 90 ± 30 s

Solder heating ; 250 °C / 10 ± 1s (260 °C peak, 2 times)

・Soldering iron ; 380 ± 10 °C / 3.5 ± 0.5s (1 time)

Electrostatic Discharge

 When handling the products, the operator must be grounded. Grounded wrist straps worn should have at least 1MΩ of

resistance from the operator to ground to prevent shock hazard, and it should be placed near the operator.

 Workbenches where the products are handled should be grounded and be provided with conductive table and floor mats.

 When using measuring equipment such as a curve tracer, the equipment should be grounded.

 When soldering the products, the head of soldering irons or the solder bath must be grounded in order to prevent leak

voltages generated by them from being applied to the products.

 The products should always be stored and transported in Sanken shipping containers or conductive containers, or be

wrapped in aluminum foil.

IMPORTANT NOTES

 The contents in this document are subject to changes, for improvement and other purposes, without notice. Make sure

that this is the latest revision of the document before use.

 Application examples, operation examples and recommended examples described in this document are quoted for the

sole purpose of reference for the use of the products herein and Sanken can assume no responsibility for any

infringement of industrial property rights, intellectual property rights, life, body, property or any other rights of Sanken

or any third party which may result from its use.

 Unless otherwise agreed in writing by Sanken, Sanken makes no warranties of any kind, whether express or implied, as

to the products, including product merchantability, and fitness for a particular purpose and special environment, and the

information, including its accuracy, usefulness, and reliability, included in this document.

 Although Sanken undertakes to enhance the quality and reliability of its products, the occurrence of failure and defect of

semiconductor products at a certain rate is inevitable. Users of Sanken products are requested to take, at their own risk,

preventative measures including safety design of the equipment or systems against any possible injury, death, fires or

damages to the society due to device failure or malfunction.

 Sanken products listed in this document are designed and intended for the use as components in general purpose

electronic equipment or apparatus (home appliances, office equipment, telecommunication equipment, measuring

equipment, etc.).

When considering the use of Sanken products in the applications where higher reliability is required (transportation

equipment and its control systems, traffic signal control systems or equipment, fire/crime alarm systems, various safety

devices, etc.), and whenever long life expectancy is required even in general purpose electronic equipment or apparatus,

please contact your nearest Sanken sales representative to discuss, prior to the use of the products herein.

The use of Sanken products without the written consent of Sanken in the applications where extremely high reliability is

required (aerospace equipment, nuclear power control systems, life support systems, etc.) is strictly prohibited.

 When using the products specified herein by either (i) combining other products or materials therewith or (ii) physically,

chemically or otherwise processing or treating the products, please duly consider all possible risks that may result from

all such uses in advance and proceed therewith at your own responsibility.

 Anti radioactive ray design is not considered for the products listed herein.

 Sanken assumes no responsibility for any troubles, such as dropping products caused during transportation out of

Sanken’s distribution network.

 The contents in this document must not be transcribed or copied without Sanken’s written consent.