| Electronic Components Datasheet Search |
|
OP230WPS Datasheet(PDF) 2 Page - TT Electronics. |
|
|
|||||||||||||||||||||||||||||
OP230WPS Datasheet(HTML) 2 Page - TT Electronics. |
|
2 / 3 page ![]() © TT electronics plc General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. Point Source Hermetic Infrared Emitting Diode OP230WPS Issue B 07/2016 Page 2 OPTEK Technology, Inc. 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www.ttelectronics.com Absolute Maximum Ratings (TA = 25° C unless otherwise noted) Storage Temperature Range -55o C to +150o C Opera ng Temperature Range -40o C to +125o C Reverse DC Voltage 2.0 V Forward Current 100 mA Lead Soldering Temperature [1/16 inch (1.6 mm) from case for 5 seconds with soldering iron] 260° C(1) Power Dissipa on 100 mW(2) Peak Forward Current (2 µs pulse width, 0.1% duty cycle) 3.0 A Electrical Specifications Electrical Characteristics (TA = 25° C unless otherwise noted) SYMBOL PARAMETER MIN TYP MAX UNITS TEST CONDITIONS EE(APT) Apertured Irradiance 0.50 - - mW/cm 2 IF = 100 mA (3 ) VF Forward Voltage - - 2.2 V IF = 100 mA IR Reverse Current - - 10 µA VR= 2.5 V λP Peak Wavelength - 850 - nm IF = 20 mA β Spectral Bandwidth @ 50% IF = 20 mA - 15 - nm IF=20 mA θHP Emission Angle at Half Power Points - ±45 - Degree IF = 20 mA tr Output Rise Time - 20 - ns IF(PK)=100 mA, PW=10 µs, and D.C.=10% tf Output Fall Time - 20 - ns IF(PK)=100 mA, PW=10 µs, and D.C.=10% Input Diode Notes: 1. All parameters tested using pulse technique. 2. RMA flux is recommended. Dura on can be extended to 10 seconds maximum when flow soldering. 3. Derate linearly 1 mW/° C above 25° C. 4. EE(APT) is a measurement of the average apertured radiant energy incident upon a sensing area 0.250” (6.35 mm) in diameter and perpendicular to and centered to the mechanical axis of the emi ng surface at a distance of 0.466” (11.84 mm). EE(APT) is not necessarily uniform within the measured area. |
|
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |