106963 datasheet(16/25 Pages) PHOENIX

16 / 25 page

TRIO-PS-2G/1AC/12DC/5/C2LPS

106963_en_00

PHOENIX CONTACT 16 / 25

Mounting/removal

11.1

Assembly

Position the module with the DIN rail guide on the upper

edge of the DIN rail, and snap it in with a downward motion.

Figure 7

Assembly on standard DIN rail

11.2

Removal

Pull the snap lever open with the aid of a screwdriver and

slide the module out at the lower edge of the DIN rail.

Figure 8

Removing the DIN rail

Device connection terminal blocks

12.1

Push-in connection technology

All connection terminal blocks on the power supply have

push-in connection technology on the front. The power

supply is wired by simply plugging in the connecting cables,

no tools are required. For the necessary connection

parameters for the terminal blocks, please refer to the

technical data.

12.1.1 Plug in connecting cable

The wiring is carried out by simply plugging the connecting

cable into the contact opening provided. Insert the

connecting cable as far as it will go.

Figure 9

Insert connecting cable (push-in connection

technology)

12.1.2 Loosen the connecting cable

To disconnect the wiring, take a suitable screwdriver and

insert it into the opening for release. Then carefully pull the

connecting cable out of the contact opening.

Figure 10

Release connecting cable (push-in connection

technology)

Click

106963 Datasheet(PDF) 16 Page - PHOENIX CONTACT