
1 (8)
DA9162.001
25 October, 2001
0$6
P$ /'29ROWDJH5HJXODWRU,&
• /RZ 1RLVH 9UPV ZLWKRXW
([WHUQDO%\SDVV&DSDFLWRU
• 9HU\6KRUW6WDUWXS7LPHV
• 6WDEOH/RZ(652XWSXW&DSDFLWRUV
• /RZ 0LQLPXP 2XWSXW&DSDFLWDQFH
5HTXLUHPHQW)
•
5HJXODWRU (QDEOH'LVDEOH&RQWURO
'(6&5,37,21
MAS9162 is a low dropout voltage regulator with an
enable/disable pin, which allows device to be turned
off or on by pulling control to low or high.
No
external
bypass
capacitor
is
needed
for
achieving the low noise level of 30 µVrms. In
addition to the noise levels, MAS9162 excels in
dropout voltage (95 mV typical at 50 mA) and in
start-up time (typically 10
µs from start-up to within
±1% of VOUT(NOM)).
The Equivalent Series Resistance (ESR) range of
output capacitors that can be used with MAS9162 is
very wide. This ESR range from a few m
Ω up to a
couple of Ohms combined with no minimum output
current requirement makes the usage of MAS9162
easier and low in cost. Also the minimum output
capacitance requirement is very low. This combined
with very short start-up time makes it possible to
switch the regulator off and on even in timing critical
and/or noise sensitive applications.
An internal thermal protection circuit prevents the
device from overheating. Also the maximum output
current is internally limited. In order to save power
the device goes into sleep mode when the regulator
is disabled.
)($785(6
$33/,&$7,21
• No External Bypass Capacitor Needed
• Optimized for Fast Start-up
• Internal Thermal Shutdown
• Short Circuit Protection
• SOT23-5 Package
• Pin Compatible with MC33761
• Several Output Voltage Options Available, See
Ordering Information p. 8
• RF-Oscillators
• Cellular Phones
• Cordless Phones
• Pagers
• Battery Powered Systems
• Portable Systems
• Radio Control Systems
3,1&21),*85$7,21
Top View
For Top Marking Information
see Ordering Information p. 8
This is preliminary information on a new
product under development. Micro Analog
Systems Oy reserves the right to make any
changes without notice.
1
2
3
5
VIN
VOUT
CTRL
GND
NC
62AX
4