GD25VE32CSIS datasheet(40/63 Pages) GIGADEVICE

40 / 63 page

Uniform Sector

Dual and Quad Serial Flash

GD25VE32C

7.32.

Read Security Registers (48H)

The Read Security Registers command is similar to Fast Read command. The command is followed by a 3-byte

address (A23-A0) and a dummy byte, and each bit is latched-in on the rising edge of SCLK. Then the memory content, at

that address, is shifted out on SO, and each bit is shifted out, at a Max frequency fC, on the falling edge of SCLK. The first

byte addressed can be at any location. The address is automatically incremented to the next higher address after each byte

of data is shifted out. Once the A9-A0 address reaches the last byte of the register (Byte 3FFH), it will reset to 000H, the

command is completed by driving CS# high.

Address

A23-16

A15-12

A11-10

A9-0

Security Register #1

00H

0 0 0 1

0 0

Byte Address

Security Register #2

00H

0 0 1 0

0 0

Byte Address

Security Register #3

00H

0 0 1 1

0 0

Byte Address

Figure 37. Read Security Registers command Sequence Diagram

7.33.

Enable Reset (66H) and Reset (99H)

If the Reset command is accepted, any on-going internal operation will be terminated and the device will return to its

default power-on state and lose all the current volatile settings, such as Volatile Status Register bits, Write Enable Latch

status (WEL), Program/Erase Suspend status, Read Parameter setting (P7-P0), Continuous Read Mode bit setting (M7-

M0) and Wrap Bit Setting (W6-W4).

The

“Reset (99H)” command sequence as follow: CS# goes low  Sending Enable Reset command  CS# goes

high  CS# goes low  Sending Reset command  CS# goes high. Once the Reset command is accepted by the device,

the device will take approximately tRST_E / tRST to reset. During this period, no command will be accepted. Data corruption

may happen if there is an on-going or suspended internal Erase or Program operation when Reset command sequence is

accepted by the device. It is recommended to check the BUSY bit and the SUS bit in Status Register before issuing the

Reset command sequence.

Command

48H

CS#

SCLK

High-Z

9 10

28 29 30 31

23 22 21

24-bit address

MSB

34 35 36 37

38 39

Data Out1

42 43 44 45

46 47

Data Out2

CS#

SCLK

MSB

Dummy Byte

GD25VE32CSIS Datasheet(PDF) 40 Page - GigaDevice Semiconductor (Beijing) Inc.

GD25VE32CSIS Datasheet(HTML) 40 Page - GigaDevice Semiconductor (Beijing) Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63

Datasheet Download

Link URL