The sensor’s compact housing has a large, easy-to-see bar

graph display plus bright LEDs for easy programming and status

monitoring during operation.

Standard models have bipolar outputs, one each NPN and PNP.

Main units with bussable power have the same bipolar outputs;

sub-units feature a single discrete output, either NPN or PNP.

Models with bussable power are designed for use in machines

and other applications where multiple sensors will be grouped

tightly. They feature increased temperature compensation

compared with standard models and reduce the amount of

wiring necessary for such applications. An accessory clamp is

available to secure a bank of connected sensors together on a

DIN rail (see Accessories on page 13).

Power ON LED (green)

Configuration status

LEDs (green)

Bussable power input

port (cap supplied for

unused port)

Output LED (yellow)

Bar graph display (red)

Switching threshold

Configuration push buttons

Bussable power output

port (cap supplied for

unused port)

Figure 1. Features

Sensor Configuration

Sensor configuration is accomplished via TEACH, Set, and Setup modes. After the sensing parameters are defined (using

either TEACH or Set mode), Setup mode may be used to enable the delay, to change the light/dark operate status, or to

select the highspeed response option (HS). Manual Adjust may be used to fine-tune the thresholds. Two push buttons,

Dynamic (+) and Static (−), or the remote wire, may be used to access and set the sensing parameters.

Sensor sensitivity may be configured using any of three methods. A single switching threshold may be achieved using

either Dynamic (on-the-fly) or Static TEACH; or Window SET may be used to define a sensing window, centered on a

single sensing condition.

Remote Configuration

The remote configuration function may be used to configure the sensor remotely or to disable the push buttons for

security. Connect the gray wire of the sensor to ground (0V dc), with a remote programming switch connected between

them. Pulse the remote line according to the diagrams in the configuration procedures. The duration of the individual

pulses is equal to the value T: 0.04 seconds ≤ T ≤ 0.8 seconds

Returning to RUN Mode

Some TEACH, Set, and Setup modes may be exited either after the 60-second timeout, or by exiting the process:

•

In Static TEACH or Window Set mode, press and hold the Static (−) button (or hold the remote line) for 2 seconds.

The sensor returns to Run mode without saving any new settings.

•

In Setup mode, press and hold both the Static (−) and Dynamic (+) buttons (or hold the remote line) for 2

seconds. The sensor returns to Run mode and saves the current setting.

2

www.bannerengineering.com - Tel: +1-763-544-3164

P/N 117830 Rev. G