Datasheet

LED Area Lights for Use with PresencePLUS P4 Sensors

•

Continuous or strobed operation, selectable via sensor software

•

Solid-state LED matrix

•

Direct connection to

•

Two available bracket options

Models

Model

LED Color

Ambient Light Filter Kit

Polarizing Filter Kit

Connector1

LEDIA62X62M

Infrared, 940 nm

FLTI (included with IR lights)

—

2 m (6.5 ft) cable with a 3-pin

M8/Pico-style quick

disconnect fitting

LEDRA62X62M

Visible red, 630 nm

FLTR (included with LEDAPFKS)

LEDAPFKS

LEDWA62X62M

White, all visible

FLTB or FLTG

LEDBA62X62M

Blue, 464 to 475 nm

FLTB

LEDGA62X62M

Green, 520 to 540 nm

FLTG

Installing the Area Light

Note: Before installing this area light it is recommended that an ambient light filter be installed behind the lens.

The filter improves image quality by reducing unwanted ambient light.

Sensing Shiny Surfaces: To eliminate direct reflections without using polarizing filters, angle the sensor approximately 15° (or more)

from perpendicular to a shiny surface.

Polarizing Kit: If it is necessary to mount the camera at a 90° angle to a shiny surface, the polarizing filter kit provides filters for both

the LED area light and sensor to reduce the negative effects of strong, direct light reflections. The red filter kit (FLTR) is included

with the polarizing kit. When light colors other than red are used, discard the red filter in the polarizing kit and use the proper filter

listed in the models table. The polarizing filters reduce the amount of light returned to the sensor.

Cleaning Instructions

Regularly remove any dust, dirt, or fingerprints from the light source.

1. Blow off dust using anti-static compressed air.

2. If necessary, use a lens cloth and lens cleaner or window cleaner to wipe off remaining debris. Do not use any other

chemicals for cleaning.

Specifications

Supply Voltage and Current

Voltage supplied by

PresencePLUS P4 sensors, if operating at 24 V dc (see

sensor manual)

Infrared: 24 V dc at 150 mA max.

All other colors: 24 V dc at 200 mA max.

Light Source

LED; see Models table for wave lengths

Illumination

High-intensity area light

Connections

2 m (6.5 ft) PVC cable with a 3-pin M8/Pico-style quick disconnect

Construction

Low-carbon steel with black zinc plating, acrylic window

Useful Life

10,000 hours (LED ON time). When operated within specifications, output

will decrease less than 30% after 10,000 hours and less than 50% (less than

40% for red and IR models) after 20,000 hours.

Operating Conditions

0° to +50°C (+32° to 122°F)

90% at 50°C (non-condensing) max. relative humidity

Certifications

1 Models with a quick disconnect require a mating cordset.

LED..A62X62M Series Area Lights

Original Document

121780 Rev. D

19 February 2019

121780