CS5463 datasheet(36/44 Pages) CIRRUS

36 / 44 page

CS5463

DS678PP1

7. SYSTEM CALIBRATION

7.1 Channel Offset and Gain Calibration

The CS5463 provides digital DC offset and gain com-

pensation that can be applied to the instantaneous volt-

age and current measurements, and AC offset

compensation to the voltage and current RMS calcula-

tions.

Since the voltage and current channels have indepen-

dent offset and gain registers, system offset and/or

gain can be performed on either channel without the

calibration results from one channel affecting the oth-

er.

The computational flow of the calibration sequences are

illustrated in Figure 12. The flow applies to both the volt-

age channel and current channel.

7.1.1 Calibration Sequence

The CS5463 must be operating in its active state and

ready to accept valid commands. Refer to Section Sec-

tion 5.15 Commands on page 23. The calibration algo-

rithms are dependent on the value N in the Cycle Count

(see Figure 12). Upon completion, the results

of the calibration are available in their corresponding

If the DRDY bit is to be output on the INT pin, then

DRDY bit in the Mask Register must be set. The initial

values in the calibration registers do affect the results of

the calibration results.

7.1.1.1 Duration of Calibration Sequence

The value of the Cycle Count Register (N) determines

the number of conversions performed by the CS5463

during a given calibration sequence. For DC offset and

gain calibrations, the calibration sequence takes at least

N + 30 conversion cycles to complete. For AC offset cal-

ibrations, the sequence takes at least 6N + 30 ADC cy-

cles to complete, (about 6 computation cycles). As N is

increased, the accuracy of calibration results will in-

crease.

7.1.2 Offset Calibration Sequence

For DC and AC offset calibrations, the VIN

± pins of the

voltage and IIN

± pins of the current channels should be

connected to their ground reference level. (see Figure

13.)

The AC offset registers must be set to the default

(0x000000).

7.1.2.1 DC Offset Calibration Sequence

Channel gain should be set to 1.0 when performing DC

offset calibration. Initiate a DC offset calibration. The DC

offset registers are updated with the negative of the av-

erage of the instantaneous samples taken over a com-

putational cycle. Upon completion of the DC offset

calibration the DC offset is stored in the corresponding

DC offset register. The DC offset value will be added to

Figure 12. Calibration Data Flow

Modulator

to V*, I* Registers

Filter

RMS*, IRMS*

Registers

DC Offset*

Gain*

0.6

* Denotes readable/writable register

√

Inverse

-1

RMS

AC Offset*

-1

XGAIN

External

Connections

0V +-

AIN+

AIN-

CM +-

Figure 13. System Calibration of Offset

CS5463 Datasheet(PDF) 36 Page - Cirrus Logic

CS5463 Datasheet(HTML) 36 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

Datasheet Download

Link URL