CS44210 datasheet(30/38 Pages) CIRRUS

30 / 38 page

CS44210

DS539PP1

and a 16 ohm load on the headphone outputs, the

minimum power-down time will be approximately

0.4 seconds.

Note that ramp up and ramp down period can be set

to zero with the RUPBYP and RDNBYP bits re-

spectively.

6.5 Recommended Power-up Sequence

6.5.1 Stand Alone Mode

1. Hold RST low until the power supply, master,

and left/right clocks are stable. In this state, the

control port is reset to its default settings and the

HP_x and DRIVER_x lines will remain low.

2. Bring RST high. The device will remain in a low

power state and will initiate the Stand-Alone pow-

er-up sequence. The control port will be accessible

at this time.

6.5.2 Control Port Mode

1. Hold RST low until the power supply, master,

and left/right clocks are stable. In this state, the

control port is reset to its default settings and the

HP_x and DRIVER_x lines will remain low.

2. Bring RST high. The device will remain in a low

power state and will initiate the Stand-Alone pow-

er-up sequence. The control port will be accessible

at this time.

3. On the CS44210 the control port pins are shared

with stand-alone configuration pins. To enable the

control port, the user must set the CP_EN bit. This

is done by performing a Two-Wire or SPI write.

Once the control port is enabled, these pins are ded-

icated to control port functionality.

To prevent audible artifacts the CP_EN bit (see

Section 4.10.4) should be set prior to the comple-

tion of the Stand-Alone power-up sequence, ap-

proximately 21mS. Writing this bit will halt the

Stand-Alone power-up sequence and initialize the

control port to its default settings. Note, the CP_EN

bit can be set any time after RST goes high; how-

ever, setting this bit after the Stand-Alone pow-

er-up sequence has completed can cause audible

artifacts.

CS44210 Datasheet(PDF) 30 Page - Cirrus Logic

CS44210 Datasheet(HTML) 30 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38

Datasheet Download

Link URL