Solder Heat Shift (%)

0

10%

20%

30%

40%

50%

0

50

100

150

200

250

300

0

50

100

150

200

250

300

350

400

Time (seconds)

C01

8

REF4132

SNAS794 – MAY 2020

www.ti.com

Product Folder Links: REF4132

Submit Documentation Feedback

Copyright © 2020, Texas Instruments Incorporated

8 Parameter Measurement Information

8.1 Solder Heat Shift

The materials used in the manufacture of the REF4132 have differing coefficients of thermal expansion, resulting

in stress on the device die when the part is heated. Mechanical and thermal stress on the device die can cause

the output voltages to shift, degrading the initial accuracy specifications of the product. Reflow soldering is a

common cause of this error.

In order to illustrate this effect, a total of 32 devices were soldered on two printed circuit boards [16 devices on

each printed circuit board (PCB)] using lead-free solder paste and the paste manufacturer suggested reflow

profile. The reflow profile is as shown in Figure 13. The printed circuit board is comprised of FR4 material. The

board thickness is 1.65 mm and the area is 114 mm × 152 mm.

Figure 13. Reflow Profile

The reference output voltage is measured before and after the reflow process; the typical shift is displayed in

Figure 14. Although all tested units exhibit very low shifts (< 0.01%), higher shifts are also possible depending on

the size, thickness, and material of the printed circuit board. An important note is that the histograms display the

typical shift for exposure to a single reflow profile. Exposure to multiple reflows, as is common on PCBs with

surface-mount components on both sides, causes additional shifts in the output bias voltage. If the PCB is

exposed to multiple reflows, the device must be soldered in the last pass to minimize its exposure to thermal

stress.