1

2

3

4

5

6

7

14

13

12

11

10

9

8

1A

1Y

2Y

3A

3Y

GND

V

CC

6A

6Y

5Y

4A

4Y

GND

V

CC

5A

2A

0.1

F

Unused input

tied to GND

Bypass capacitor

placed close to

the device

Avoid 90°

corners for

signal lines

Recommend GND flood fill for

improved signal isolation, noise

reduction, and thermal dissipation

Unused output

left floating

Unused input

11

SN74HCS05

www.ti.com

SCLS797 – JUNE 2020

Product Folder Links: SN74HCS05

Submit Documentation Feedback

Copyright © 2020, Texas Instruments Incorporated

10 Power Supply Recommendations

The power supply can be any voltage between the minimum and maximum supply voltage rating located in the

disturbance. A 0.1-μF capacitor is recommended for this device. It is acceptable to parallel multiple bypass caps

to reject different frequencies of noise. The 0.1-μF and 1-μF capacitors are commonly used in parallel. The

bypass capacitor should be installed as close to the power terminal as possible for best results, as shown in

Figure 10.

11 Layout

11.1 Layout Guidelines

When using multiple-input and multiple-channel logic devices inputs must not ever be left floating. In many

cases, functions or parts of functions of digital logic devices are unused; for example, when only two inputs of a

triple-input AND gate are used. Such unused input pins must not be left unconnected because the undefined

voltages at the outside connections result in undefined operational states. All unused inputs of digital logic

devices must be connected to a logic high or logic low voltage, as defined by the input voltage specifications, to

prevent them from floating. The logic level that must be applied to any particular unused input depends on the

function or is more convenient.

11.2 Layout Example

Figure 10. Example layout for the SN74HCS05