XRT7250 datasheet(380/463 Pages) EXAR

380 / 463 page

áç

XRT7250

DS3/E3 FRAMER IC

REV. 1.1.1

361

head Data Input Interface. Method 2 involves the use

of the following signals:

• TxOH

• TxInClk

• TxOHFrame

• TxOHEnable

Each of these signals are listed and described in

Table 74.

Interfacing the Transmit Overhead Data Input Interface

to the Terminal Equipment

Figure 172 illustrates how one should interface the

Transmit Overhead Data Input Interface to the Termi-

nal Equipment when using Method 2.

TABLE 74: DESCRIPTION OF METHOD 1 TRANSMIT OVERHEAD INPUT INTERFACE SIGNALS

NAME

TYPE

DESCRIPTION

TxOHEnable

Output

Transmit Overhead Data Enable Output pin

The XRT7250 will assert this signal, for one TxInClk period, just prior to the instant that

the Transmit Overhead Data Input Interface is processing an overhead bit.

TxOHFrame

Output

Transmit Overhead Input Interface Frame Boundary Indicator Output:

This output signal pulses "High" when the XRT7250 is processing the last bit within a

given DS3 frame.

TxOHIns

Input

Transmit Overhead Data Insert Enable input pin.

Asserting this input signal (e.g., setting it "High") enables the Transmit Overhead Data Input Inter-

face to accept overhead data from the Terminal Equipment. In other words, while this input pin is

"High", the Transmit Overhead Data Input Interface will sample the data at the TxOH input pin, on

the falling edge of the TxInClk output signal.

Conversely, setting this pin "Low" configures the Transmit Overhead Data Input Interface to NOT

sample (e.g., ignore) the data at the TxOH input pin, on the falling edge of the TxOHClk output

signal.

NOTE: If the Terminal Equipment attempts to insert an overhead bit that cannot be accepted by

the Transmit Overhead Data Input Interface (e.g., if the Terminal Equipment asserts the TxOHIns

signal, at a time when one of these non-insertable overhead bits are being processed), that par-

ticular insertion effort will be ignored.

TxOH

Input

Transmit Overhead Data Input pin:

The Transmit Overhead Data Input Interface accepts the overhead data via this input

pin, and inserts into the overhead bit position within the very next Outbound DS3 frame.

If the TxOHIns pin is pulled "High", the Transmit Overhead Data Input Interface will sam-

ple the data at this input pin (TxOH), on the falling edge of the TxOHClk output pin.

Conversely, if the TxOHIns pin is pulled "Low", then the Transmit Overhead Data Input

Interface will NOT sample the data at this input pin (TxOH). Consequently, this data will

be ignored.

XRT7250 Datasheet(PDF) 380 Page - Exar Corporation

XRT7250 Datasheet(HTML) 380 Page - Exar Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL