Electronic Components Datasheet Search
  English  ▼

X  

TS34118CS Datasheet(PDF) 10 Page - Taiwan Semiconductor Company, Ltd

Part # TS34118CS
Description  Voice Switched Speakerphone Circuit
PDF  20 Pages
Scroll/Zoom Zoom In 100%  Zoom Out
Manufacturer  TSC [Taiwan Semiconductor Company, Ltd]
Direct Link  http://www.taiwansemi.com
Logo TSC - Taiwan Semiconductor Company, Ltd

TS34118CS Datasheet(HTML) 10 Page - Taiwan Semiconductor Company, Ltd

Back Button TS34118CS Datasheet HTML 6Page - Taiwan Semiconductor Company, Ltd TS34118CS Datasheet HTML 7Page - Taiwan Semiconductor Company, Ltd TS34118CS Datasheet HTML 8Page - Taiwan Semiconductor Company, Ltd TS34118CS Datasheet HTML 9Page - Taiwan Semiconductor Company, Ltd TS34118CS Datasheet HTML 10Page - Taiwan Semiconductor Company, Ltd TS34118CS Datasheet HTML 11Page - Taiwan Semiconductor Company, Ltd TS34118CS Datasheet HTML 12Page - Taiwan Semiconductor Company, Ltd TS34118CS Datasheet HTML 13Page - Taiwan Semiconductor Company, Ltd TS34118CS Datasheet HTML 14Page - Taiwan Semiconductor Company, Ltd Next Button
Zoom Inzoom in Zoom Outzoom out
 10 / 20 page
background image
TS34118
10-20
2004/09 rev. B
Attenuator Control Block
The Attenuator Control Block has the seven inputs described above:
-The output of the comparator operated by RLO2 and TLO2 (microphone/speaker side) - designated C1.
-The output of the comparator operated by RLO1 and TLO1 (TIP/Ring side) – designated C2.
-The output of the transmit background noise monitor – designated C3.
-The output of the receive background noise monitor
-designated C4.
-The volume control.
-The dial tone detector.
-The AGC circuit.
The single output of the Control Block controls the two attenuators. The effect of C1-C4 is as follows:
Input
Output
C1
C2
C3
C4
Mode
Tx
Tx
1
X
Transmit
Tx
Rx
Y
Y
Fast Idle
Rx
Tx
Y
y
Fast Idle
Rx
Rx
X
1
Receive
Tx
Tx
0
X
Slow Idle
Tx
Rx
0
0
Slow Idle
Rx
Tx
0
0
Slow Idle
Rx
Rx
X
0
Slow Idle
X=Don’t Care; y=C3 and C4 are not both 0. A definition of the above terms:
1)”Transmit” means the transmit attenuator is fully on (+6.0dB), and the receive attenuator is at max. attenuation
(-46dB).
2)”Receive” means both attenuators are controlled by the volume control. At max. Volume, the receive attenuator is fully
on (+6.0dB), and the transmit attenuator is at max. attenuation (-46dB).
3)”Fast Idle” means both transmit and receive speech is present in approximately equal levels. The attenuators are
quickly switched (30ms) to idle until one speech level dominates the other.
4)”Slow Idle” means speech has ceased in both transmit and receive paths. The attenuators are then slowly switched (1
second) to the idle mode.
5) Switch to the full transmit or receive modes from any other mode is at the fast rate (≈30ms).
A summary of the truth table is as follows:
1)The circuit will switch to transmit if: a) both transmit level detectors sense higher signal levels relative to the respective
receive level detectors (TLI1 versus RLI1, TLI2 versus RLI2), and b) the transmit background noise monitor indicates
the presence of speech.
2)The circuit will switch to receive if: a) both receive level detectors sense higher signal levels relative to the respective
transmit level detectors, and b) the receive background noise monitor indicates the presence of speech.
3) The circuit will switch to the fast idle mode if the level detectors disagree on the relative strengths of the signal
levels, and at least one of the background noise monitors indicates speech. For example, referring to the Block
Diagram (Figure 2), if there is sufficient signal at the microphone amp output (TLI2) to override the speaker signal
(RLI2), and there is sufficient signal at the receive input (RLI1) to override the signal at the hybrid output (TLI1), and
either or both background monitors indicate speech, then the circuit will be in the fast idle mode. Two conditions
which can cause the fast idle mode to occur are a) when both talkers are attempting to gain control of the system by
talking at the same time, and b)when one talker is in a very noisy environment, forcing the other talker to continually
override that noise level. In general, the fast idle mode will occur infrequently.



Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20


Datasheet Download

Go To PDF Page


Link URL



Does ALLDATASHEET help your business so far?  [ DONATE ] 

About Alldatasheet   |   Advertisement   |   Contact us   |   Privacy Policy   |   Link to Datasheet    |   Link Exchange   |   Manufacturer List
All Rights Reserved©Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn
Indian : Alldatasheet.in  |   Mexican : Alldatasheet.com.mx  |   British : Alldatasheet.co.uk  |   New Zealand : Alldatasheet.co.nz
Family Site : ic2ic.com  |   icmetro.com