®

AS7C33512PFS18A

11/30/04; v.2.2

Alliance Semiconductor

4 of 20

Functional description

The AS7C33512PFS18A is a high performance CMOS 8-Mbit Synchronous Static Random Access Memory (SRAM) device organized as

524,288 words × 18 bits and incorporate a pipeline for highest frequency on any given technology.

permit easy memory expansion. Burst operation is initiated in one of two ways: the controller address strobe (ADSC), or the processor

address strobe (ADSP). The burst advance pin (ADV) allows subsequent internally generated burst addresses.

Read cycles are initiated with ADSP (regardless of WE and ADSC) using the new external address clocked into the on-chip address register.

When ADSP is sampled LOW, the chip enables are sampled active, and the output buffer is enabled with OE. In a read operation the data

accessed by the current address, registered in the address registers by the positive edge of CLK, are carried to the data-out registers and

driven on the output pins on the next positive edge of CLK. ADV is ignored on the clock edge that samples ADSP asserted but is sampled on

all subsequent clock edges. Address is incremented internally for the next access of the burst when ADV is sampled LOW and both address

Write cycles are performed by disabling the output buffers with OE and asserting a write command. A global write enable GWE writes all

18 bits regardless of the state of individual BW[a:b] inputs. Alternately, when GWE is HIGH, one or more bytes may be written by asserting

BWE and the appropriate individual byte BWn signal(s).

BWn is ignored on the clock edge that samples ADSP LOW, but is sampled on all subsequent clock edges. Output buffers are disabled when

BWn is sampled LOW (regardless of OE). Data is clocked into the data input register when BWn is sampled LOW. Address is incremented

internally to the next burst address if BWn and ADV are sampled LOW.

This device operates in single-cycle deselect feature during

read cycles.

Read or write cycles may also be initiated with ADSC instead of ADSP. The differences between cycles initiated with ADSC and ADSP are

as follows:

• ADSP must be sampled HIGH when ADSC is sampled LOW to initiate a cycle with ADSC.

• WE signals are sampled on the clock edge that samples ADSC LOW (and ADSP HIGH).

• Master chip select CE0 blocks ADSP, but not ADSC.

The AS7C33512PFS18A operate from a 3.3V supply. I/Os use a separate power supply that can operate at 2.5V or 3.3V. These devices are

available in a 100-pin 14×20 mm TQFP packaging.

.

*Guaranteed not tested

Capacitance

Parameter

Symbol

Test conditions

Max

Unit

Input capacitance

5

pF

I/O capacitance

7

pF

TQFP thermal resistance

Description

Conditions

Symbol

Typical

Units

Thermal resistance

1 This parameter is sampled.

Test conditions follow standard test

methods and procedures for measuring

thermal impedance, per EIA/JESD51

1–layer

40

°C/W

4–layer

22

°C/W

Thermal resistance

(junction to top of case)1

8

°C/W