3M™ Hot Melt Adhesive

3762LM • 3762

Directions for

Open Time is the maximum amount of time between dispensing adhesive and joining surfaces.

Reported open time are based on 1/8” extruded beads and will vary based on bead size, dispense

temperature and ambient temperature.

Extruded bead sizes can be customized using 3M™ applicator tips.

3. Coverage:3M™ Hot Melt Adhesives yield approximately 430 linear feet per pound of

adhesive when extruded as a 1/8” diameter semi-circular bead.

4. Set Time: After the bond is made, 3M™ Hot Melt Adhesives immediately build

strength and no clamping is necessary. Set will occur faster on cold or metallic

substrates.

Typical

Application

Properties

Note: The following technical information and data should be considered representative

or typical only and should not be used for specification purposes

(1) Recommended application temperature range. Temperature can be adjusted to regulate desired

viscosity, delivery rate and pot life.

(2) Brookfield Thermocel Viscometer in Centipoise using a #27 Spindle @ 10 RPM.

(3) For 1/8” semicircular bead, Douglas Fir to Douglas Fir.

(4) Extrusion time for one 1”x3” PG cartridge.

Typical

Performance

Properties

Note: The following technical information and data should be considered representative

or typical only and should not be used for specification purposes.

3M™ Hot Melt Adhesive

3762LM

3762

130°F/ 54°C

130°F/ 54°C

205°F/ 96°C

201°F/ 94°C

480 psi

545 psi

6 pwi

7 pwi

UL94 Listing

n/a

V2

FDA Indirect Food

21 CFR 175.105

21 CFR 175.105

(1) Highest temperature that the adhesive will support a 2 psi dead load .

(2) ASTM E28-67.

(3) Douglas Fir to Douglas Fir.

(4) Canvas to Douglas Fir.

(5) Permitted for indirect food contact subject to the limitations in applicable CFR section(s).

3M™ Hot Melt Adhesive

3762LM

3762

Application

250-270°F/ 121-132°C

350-385°F/ 177-196°C

4000 @ 250°F

1870 @ 375°F

25

35

45

30

Available sizes/forms

5/8”x8”Q

5/8”x2” TC

1”x3” PG

1/2”x12”AE

1/8” Bulk

5/8”x8”Q

5/8”x2” TC

1”x3” PG

1/2”x12”AE