Spread Spectrum Clock Synthesizer

MDS 650-41 F

3

Revision 082305

Integrated Circuit Systems, Inc.

ICS650-41

Pin Descriptions

External Components

Decoupling Capacitor

As with any high-performance mixed-signal IC, the

ICS650-41 must be isolated from system power supply

noise to perform optimally.

A decoupling capacitor of 0.01µF must be connected

between each VDD and the PCB ground plane.

Series Termination Resistor

Clock output traces over one inch should use series

termination. To series terminate a 50

Ω trace (a

commonly used trace impedance), place a 33

Ω resistor

in series with the clock line, as close to the clock output

pin as possible. The nominal impedance of the clock

output is 20

Ω.

Crystal Load Capacitors

The device crystal connections should include pads for

small capacitors from X1 to ground and from X2 to

ground. These capacitors are used to adjust the stray

capacitance of the board to match the nominally

required crystal load capacitance. Because load

capacitance can only be increased in this trimming

process, it is important to keep stray capacitance to a

minimum by using very short PCB traces (and no vias)

between the crystal and device. Crystal capacitors

must be connected from each of the pins X1 and X2 to

ground.

The value (in pF) of these crystal caps should equal

capacitance in pF. Example: For a crystal with a 16 pF

load capacitance, each crystal capacitor would be 20

pF [(16-6) x 2] = 20.

Pin

Number

Pin Name

Pin

Type

Pin Description

1

X1/CLKIN

Input

Crystal input. Connect this pin to a 25 MHz crystal or external input

clock.

2

FS0

Input

Select pin 0. Internal pull-up resistor. See table on page 2.

3

FS1

Input

Select pin 1. Internal pull-up resistor. See table on page 2.

4

SS_EN

Input

Spread spectrum enable pin. Internal pull-up resistor. Enabled = high.

5

VDD

Power

Connect to +3.3 V.

6

GND

Power

Connect to ground.

7

FS3

Input

Select pin 3. Internal pull-up resistor. See table on page 2.

8

48M

Output

Fixed 48 MHz output. Weak internal pull-down when tri-state.

9

50M

Output

Spread Spectrum output. Weak internal pull-down when tri-stated.

10

VDDO

Power

Connect to +2.5 V.

11

GND

Power

Connect to ground.

12

VDD

Power

Connect to +3.3 V.

13

FS2

Input

Select pin 2. Internal pull-up resistor. See table on page 2.

14

PDTS

Input

Powers down entire chip. Tri-states CLK outputs when low. Internal

pull-up.

15

VDD

Power

Connect to +3.3 V.

16

X2

Output

Crystal Output. Connect this pin to a 25 MHz crystal. Do not connect if

clock input is used.