MPC7448 datasheet(5/8 Pages) NXP

5 / 8 page

MPC7448 Hardware Specifications Addendum for the MC7448Txxnnnnmx Series, Rev. 2

Freescale Semiconductor

General Parameters

5.3

Voltage and Frequency Derating

To reduce power consumption, these devices support voltage and frequency derating in which the core

voltage (VDD) may be reduced if the reduced maximum processor core frequency requirements are

observed. The supported derated core voltage, resulting maximum processor core frequency (fcore), and

power consumption are provided in Table 11. Only those parameters in Table 11 are affected; all other

parameter specifications are unaffected.

Table 8. Clock AC Timing Specifications

At recommended operating conditions. See Table 4.

Characteristic

Symbol

Maximum Processor Core Frequency (MHz)

Unit

Notes

1000N

1267N

1400N

1700L

Min

Max

Min

Max

Min

Max

Min

Max

Processor frequency

DFS mode disabled

fcore

500

1000

500

1267

500

1400

600

1700

MHz

1, 8, 9

Processor frequency

DFS mode enabled

fcore_DFS

250

500

250

633

250

700

300

850

MHz

VCO frequency

fVCO

500

1000

500

1267

500

1400

600

1700

MHz

1, 9

Notes:

1. Caution: The SYSCLK frequency and PLL_CFG[0:5] settings must be chosen such that the resulting SYSCLK (bus)

frequency, processor core frequency, and PLL (VCO) frequency do not exceed their respective maximum or minimum

operating frequencies. Refer to the PLL_CFG[0:5] signal description in Section 9.1.1, “PLL Configuration,” in the hardware

specifications for valid PLL_CFG[0:5] settings.

8. This reflects the maximum and minimum core frequencies when the dynamic frequency switching feature (DFS) is disabled.

fcore_DFS provides the maximum and minimum core frequencies in a DFS mode.

9. Caution: These values specify the maximum processor core and VCO frequencies when the device is operated at the

nominal core voltage. If operating the device at the derated core voltage, the processor core and VCO frequencies must be

reduced. See Section 5.3, “Voltage and Frequency Derating,” for more information.

10.This specification supports the Dynamic Frequency Switching (DFS) feature and is applicable only when one of the DFS

modes (divide-by-2 or divide-by-4) is enabled. When DFS is disabled, the core frequency must conform to the maximum and

minimum frequencies stated for fcore.

Table 11. Supported Voltage, Core Frequency, and Power Consumption Derating

Maximum Rated

Core Frequency

(Device Marking)

Supported

Derated Core

Voltage (VDD)

Maximum Derated

Core Frequency

(fcore)

Full-Power Mode Power Consumption

Typical

Thermal

Maximum

1000N

N/A

1267N

1.0 V ± 50 mV

1000 MHz

6.0 W

7.3 W

8.5 W

1400N

1.0 V ± 50 mV

1000 MHz

8.0 W

9.9 W

11.5 W

1700L

N/A

MPC7448 Datasheet(PDF) 5 Page - NXP Semiconductors

MPC7448 Datasheet(HTML) 5 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8

Datasheet Download

Link URL