CW2200 datasheet(2/2 Pages) ETC

2 / 2 page

USAGE INSTRUCTIONS

Read MSDS carefully prior to use.

Cleaning: For best adhesion, clean board with one

of Chemtronics Electro-Wash



or Pow-R-Wash



solvents

order

remove

any

surface

contamination which may prevent adequate material

contact.

Mixing: Although this system has been formulated

resist

hard-packing,

should

shaken

vigorously for 30 seconds to insure the proper

dispersion of the silver flakes.

If pen has been

allowed to sit idle for a long period of time, the

mixing ball may seize in the barrel. To free the ball

use force to tap the barrel end of the pen until the

ball begins to move inside the pen.

Application:

The conductive ink is dispensed

through

the

CircuitWorks



Conductive

Pen.

Squeezing the pen body while pressing down on the

surface will allow the material to flow, enabling the

trace to be drawn.

Practice with the pen before

attempting detail work.

The bulk form of this

material may be applied by brushing, banding, or

automatic dispensing equipment.

Thinning: The conductive ink has been optimized

for the CircuitWorks



Conductive Pen and thinning

is not normally necessary. However, Butyl Acetate

may be added with thorough mixing to make slight

adjustments for ease of application in the bulk form.

Clean-up/Removal:

The conductive ink may be

cleaned or removed using a strong organic solvent

such as Chemtronics



Electro-Wash



PX.

Curing:

Tack-free in 3 to 5 minutes at room

temperature.

Achieves

electrical

conductivity

within 30 minutes. Heat cure for 5 minutes at 250

to 300F (120 to 150C) for maximum conductivity,

durability and chemical resistance.

Soldering: Low temperature soldering is possible

to the heat-cured silver conductive traces if done at

350F (177C) for <5 seconds.

AVAILABILITY

CW2200STP 8.5 g (0.3 oz.), Standard 1.2 mm tip

CW2200MTP 8.5g (0.3 oz.), MicroTip 0.8 mm tip

TECHNICAL & APPLICATION

ASSISTANCE

Chemtronics



provides a technical hotline to answer

your technical and application related questions.

The toll free number is: 1-800-TECH-401.

NOTE:

This information is believed to be accurate. It is

intended for professional end users having the skills

evaluate

and

use

the

data

properly.

CHEMTRONICS does not guarantee the accuracy

of the data and assumes no liability in connection

with damages incurred while using it.

CHEMTRONICS

8125 COBB CENTER DRIVE

KENNESAW, GA 30152

1-770-424-4888

REV. H (01/17)

DISTRIBUTED BY:

CW2200 Datasheet(PDF) 2 Page - List of Unclassifed Manufacturers

CW2200 Datasheet(HTML) 2 Page - List of Unclassifed Manufacturers

Html Pages

1 2

Datasheet Download

Link URL