9726 datasheet(8/26 Pages) 3M

Part #	9726

Description	Scotch-Weld™ Hot Melt Applicator PG II LT Owner’s Manual

PDF	26 Pages

Scroll/Zoom	100%

Manufacturer	3M [3M Electronics]

Direct Link	http://www.3m.com

Logo

8 / 26 page

Operation

Changing Tips

Caution

Contact with molten adhesive or hot applicator tip or

metal components may cause burns. Wear heat-

resistant gloves and safety glasses when operating or

repairing the 3M™ Scotch-Weld™ Hot Melt

Applicator PG II LT.

The 3M Scotch-Weld Hot Melt Applicator PG II LT

includes a 9921 (.093’’) tip as standard equipment.

Other tips, available from your 3M Scotch-Weld Hot

Melt Adhesive distributor, are shown on page 22 of

this manual.

Note

Disconnect air supply before changing tips.

Tips can be changed only when the applicator is

hot. You will need a 5/8’’ and a 1/2’’ open-end

wrench. Hold the nozzle valve hex firmly with the

5/8’’ wench, while removing the nozzle tip with the

1/2’’ wrench. The accessory tip is mounted using the

reverse procedure. Snug the tip lightly.

Note

Do not tighten the tip. Overtightening could

damage the valve assembly.

9726 Datasheet(PDF) 8 Page - 3M Electronics