MCP79521 datasheet(15/58 Pages) MICROCHIP

15 / 58 page

 2012-2022 Microchip Technology Inc. and its subsidiaries

DS20002300D-page 15

MCP7951X/MCP7952X

FIGURE 5-4:

SUGGESTED PLACEMENT OF THE OSCILLATOR CIRCUIT

5.2.2

EXTERNAL CLOCK INPUT

A 32.768 kHz external clock source can be connected

to the X1 pin (Figure 5-5). When using this

configuration, the X2 pin should be left floating.

FIGURE 5-5:

EXTERNAL CLOCK INPUT

OPERATION

5.2.3

OSCILLATOR FAILURE STATUS

The MCP795XX features an oscillator failure flag,

OSCRUN, that indicates whether or not the oscillator is

running. The OSCRUN bit is automatically set after 32

oscillator cycles are detected. If no oscillator cycles are

detected for more than TOSF, then the OSCRUN bit is

automatically cleared (Figure 5-6). This can occur if the

oscillator is stopped by clearing the ST bit or due to

oscillator failure.

FIGURE 5-6:

OSCILLATOR FAILURE STATUS TIMING DIAGRAM

GND

DEVICE PINS

CX1

CX2

GND

Bottom Layer

Copper Pour

Oscillator

Crystal

Top Layer Copper Pour

CX1

CX2

DEVICE PINS

(tied to ground)

Single-Sided and In-line Layouts:

Fine-Pitch (Dual-Sided) Layouts:

Oscillator

Crystal

Copper Pour

(tied to ground)

Note:

The EXTOSC bit must be set to enable an

external clock source.

Clock from

Ext. Source

MCP795XX

OSCRUN Bit

< TOSF

TOSF

32 Clock Cycles

MCP79521 Datasheet(PDF) 15 Page - Microchip Technology

MCP79521 Datasheet(HTML) 15 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58

Datasheet Download

Link URL