TMUX4051 datasheet(13/30 Pages) TI

13 / 30 page

8 Parameter Measurement Information

8.1 On-Resistance

The on-resistance of a device is the ohmic resistance between the source (Sx) and drain (D) pins of the

device. The on-resistance varies with input voltage and supply voltage. The symbol RON is used to denote

on-resistance. The measurement setup used to measure RON is shown in the following figure. Figure 8-1 shows

how the RON is computed with RON = V / ISD, and the voltage (V) and current (ISD) are measured using this

setup.

Figure 8-1. On-Resistance Measurement Setup

8.2 Off-Leakage Current

There are two types of leakage currents associated with a switch during the off state:

1. Source off-leakage current.

2. Drain off-leakage current.

Source leakage current is defined as the leakage current flowing into or out of the source pin when the switch is

off. This current is denoted by the symbol IS(OFF).

Drain leakage current is defined as the leakage current flowing into or out of the drain pin when the switch is off.

This current is denoted by the symbol ID(OFF).

Figure 8-2 shows the setup used to measure both off-leakage currents.

VDD

GND

ID (OFF)

VDD

GND

Is (OFF)

Figure 8-2. Off-Leakage Measurement Setup

www.ti.com

TMUX4051-Q1, TMUX4052-Q1

SCDS463 – JUNE 2022

Submit Document Feedback

Product Folder Links: TMUX4051-Q1 TMUX4052-Q1

TMUX4051 Datasheet(PDF) 13 Page - Texas Instruments