PI5A4684 datasheet(2/8 Pages) PERICOM

2 / 8 page

PS8792B

05/09/06

PI5A4684

Chip Scale Packaging,

Dual SPDT Analog Switch

Recommended Operating Conditions(3)

Supply Voltage Operating (VCC) . . . . . . . . . . . . 1.65V to 5.5V

Control Input Voltage (VIN) . . . . . . . . . . . . . . . . . . . 0V to VCC

Switch Input Voltage (VIN). . . . . . . . . . . . . . . . . . . . 0V to VCC

Output Voltage (VOUT) . . . . . . . . . . . . . . . . . . . . . . . 0V to VCC

Operating Temperature (TA) . . . . . . . . . . . . . . . –40°C to +85°C

Input Rise and Fall Time (tr,tf)

Control Input VCC = 2.3V - 3.6V. . . . . . . . . 0ns/V to 10ns/V

Control Input VCC = 4.5V - 5.5V. . . . . . . . . . 0ns/V to 5ns/V

Thermal Resistance (θJA) . . . . . . . . . . . . . . . . . . . . . . 350°C/W

Lead Temperature (soldering 10s) . . . . . . . . . . . . . . . . . +300°C

Bump Temperature (soldering notes)

Infared (15s). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +220°C

Vapor Phase (60ns) . . . . . . . . . . . . . . . . . . . . . . . . . . +215°C

Absolute Maximum Ratings(1)

Supply Voltage VCC ............................................ –0.5V to +7V

DC Switch Voltage (VS)(2) ........................–0.5V to VCC +0.5V

DC Input Voltage (VIN)(2) ................................ –0.5V to +7.0V

Continuous Current NO_NC_COM_ .............................. ±500mA

Peak Current NO_NC_COM_

(pulsed at 1ms 50% duty cycle) ............................... ±650mA

Peak Current NO_NC_COM_

(pulsed at 1ms 10% duty cycle) ............................... ±800mA

Storage Temperature Range (TSTG) .............. –65°C to +150°C

Junction Temperature under Bias (TJ) .............................150°C

Junction Lead Temperature (TL)

(Soldering, 10 seconds) ................................................260°C

Power Dissipation (PD) @ +85°C .................................. 250mW

Notes:

"Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the device at these or any

other conditions beyond those indicated in the operational sections of this specification is not implied.

The input and output negative voltage ratings may be exceeded if the inut and output diode current ratings are observed.

Control input must be held HIGH or LOW; it must not float.

06-0062

PI5A4684 Datasheet(PDF) 2 Page - Pericom Semiconductor Corporation