EVAL-ADA4571-2 User Guide

UG-1047

One Technology Way • P.O. Box 9106 • Norwood, MA 02062-9106, U.S.A. • Tel: 781.329.4700 • Fax: 781.461.3113 • www.analog.com

Evaluation Board for the ADA4571-2 Integrated AMR Angle Sensor and

Signal Conditioner

PLEASE SEE THE LAST PAGE FOR AN IMPORTANT

WARNING AND LEGAL TERMS AND CONDITIONS.

Rev. 0 | Page 1 of 9

FEATURES

USB 2.0 interface

Jumper or computer controlled temperature compensation

mode enable

Jumper or computer controlled power-down mode enable

Measurement test points and coaxial connectors

EVALUATION KIT CONTENTS

ADA4571-2 magnetic stimulus

Dipole magnet

Hand movable mounting

Read back electronics

ADDITIONAL EQUIPMENT NEEDED

6 V to 12 V bench supply (optional)

SDP-S controller board

USB cable (supplied with the SDP-S controller board)

LabVIEW 2013 software downloadable from ADA4571-2

product page

GENERAL DESCRIPTION

The EVAL-ADA4571-2 shows the ADA4571-2 in an end of shaft

magnet configuration. The evaluation kit is composed of an

ADA4571-2 motherboard, a magnetic stimulus on a hand turnable

mount, a USB interface, and an SDP-S controller board. The

required LabVIEW 2013 graphical user interface (GUI) software

for Windows® is available on the ADA4571-2 product page.

The EVAL-ADA4571-2 features an on-board 5 V regulator, a

6-channel simultaneous sampling analog-to-digital converter

(ADC), and jumpers for enabling the temperature compensation

and power-down modes within the ADA4571-2. The motherboard

also features test points and unpopulated coaxial connectors for

the six outputs of the device.

The SDP-S controller board controls the ADC on the motherboard

reading back the ADA4571-2 outputs, to change the digital inputs

to the ADA4571-2, interface with the GUI, and to supply power

to the evaluation board through the USB connection.

ADA4571-2 END OF SHAFT EVALUATION SYSTEM

Figure 1.