REF70_V07 datasheet(23/43 Pages) TI

23 / 43 page

Time 1s/div

Figure 8-11. 0.1-Hz to 10-Hz Voltage Noise

8.4.2 Broadband Noise

Broadband noise is a noise that appears at higher frequency compared to 1/f noise. The broadband noise is

usually flat and uniform over frequency as shown in Figure 8-13. The broadband noise is measured by high-pass

filtering the output of the REF70 and measuring the result on a spectrum analyzer as shown in Figure 8-12.

The DC component of the REF70 is removed by using a high-pass filter and then amplified. When measuring

broadband noise, it is not necessary to have high gain in order to achieve maximum bandwidth.

REF70xx

GND

OUTS

OUTF

VIN EN

VIN

CIN

VREFP

Spectrum

Analyzer

Post Amplifier

G = 11

High-pass Filter

G = 11

Figure 8-12. Broadband Noise Test Setup

For noise sensitive designs, a low-pass filter can be used to reduce broadband noise output noise levels by

removing the high frequency components. When designing a low-pass filter special care must be taken to

ensure the output impedance of the filter does not degrade ac performance. This can occur in RC low-pass

filters where a large series resistance can impact the load transients due to output current fluctuations.

Frequency (Hz)

100

10k

100k

Figure 8-13. Noise Performance 10 Hz to 100 kHz

www.ti.com

REF70

SNAS781F – OCTOBER 2020 – REVISED MARCH 2023

Submit Document Feedback

Product Folder Links: REF70

REF70 Datasheet(PDF) 23 Page - Texas Instruments