ELECTRONICS

FCI Electronics

Manual Part No. 415988-001

Issued: Date (03/12/99)

Page 14 of 18

Rev. 05/07/01 ECR V10337

Revision B

K\DCU\Manuals

2. Remove the two holding spring’s (17) and the guide pins (15) from the terminal holder.

3. Loosen the two 2-56 setscrews (12) in the top of the terminal holder (10), which secure the

holding pins (14).

4. Using needle-nose pliers, remove both holding pins (14) by pulling straight out from terminal

holder (10). Discard the damaged holding pin(s).

Holding Pin Installation

CAUTION

Over tightening the two 2-56 setscrews (12) in the top of the terminal holder (10) can

flatten the holding pins (14), making them extremely difficult to remove.

1. Install two new holding pins (14) (0.025 in. square BergPin™ material 0.430 in. long) into

terminal holder (10) until pins are flush with the extended supports. Be sure that a flat side of

each pin is at right angles to the two 2-56 setscrew holes on top of the terminal holder (10).

2. Lightly tighten the two 2-56 setscrews (12) into the terminal holder (10) to secure the holding

pins (14).

3. Re-install the two guides pins (15), "0" rings (16), and the two holding spring’s (17).

4. Re-install the terminal holder (10) to the anvil holder (4), and tighten the two 2-56 setscrews

(12) in the anvil holder (4) onto the flats of the guide pins (15).

5. Crimp a terminal to a proper-sized wire, and inspect the terminal as described in Section II,

paragraph B.

PDM: Rev:B

Released

STATUS:

Printed: Dec 19, 2002