N–12

N

COLOR/MARKING/STOPS

SEAL

Signal traces cut except for common(s).

FIG. 1

FIG. 2

9

ANY COMBINATION OF TERMINATION

CONFIGURATIONS OR SPECIAL TERMINATIONS.

P

SOLDER PINS WITH .156” SPACING

N

SOLDER PINS WITH .100” SPACING

1

TYPE 1, EXTENDED TYPE 0

0

TYPE 0

3

SEALED SWITCHING CONTACTS AND DUST LENS

2

DUST LENS. (Protects the character face of the wheel from abrasion and dirt).

1

SEALED SWITCHING CONTACTS. (Sealing is by means of an o-ring rotary seal and a cured-in-place elastomer gasket.

Switching contact area is protected from moisture, oil, and airborne contaminants.)

0

UNSEALED SWITCHING CONTACTS.

0

MATTE BLACK HOUSING (Gloss black wheel with white characters; no stops.)

PC Board 1/32" (0,79) thick.

NOTE: See function codes, pages N–9 and N–10, for signal locations.

NOTE: Stop pins are available separately, see page N–14.

Dust Lens

NOTE: All terminal holes shown may not be present for all function codes, consult Customer Service Center.

Terminal connector available for termination options 0 & 1, see page N–14.

Specify on configuration form, page N–15

and consult Customer Service Center.

Terminal Location Numbers

C&K 3 Series

Thumbwheel Switches

TERMINATIONS

Dimensions are shown: Inch (mm)

Specifications and dimensions subject to change

www.ittcannon.com

NOTE: Termination option N (RoHS compliant) replaced termination option 3 (Non-RoHS compliant).

Termination option P (RoHS compliant) replaced termination option B (Non-RoHS compliant).