Power Supplies

3

Contact

Technical Services at (800) 377-4384 with any questions.

Visit our website at www.solahd.com.

119

Description

Catalog Number

SDN 5-24-100C

SDN 10-24-100C

Input

Nominal Voltage

115 - 230 Vac

-AC Range

85 - 264 Vac

-DC Range 1

90 - 375 Vdc

-Frequency

43 - 67 Hz

Nominal Current 2

1.65 - 0.55 A

3.2 - 1.0 A

-Inrush current max.

Typ. < 15 A

Typ.< 30 A

Efficiency (Losses 3)

> 88% typ. (14 W)

> 90% typ. (24 W)

Power Factor Correction

Active power factor correction to better than 0.92

Output

Nominal Voltage 4

24 V (23.5~28.5 Vdc Adj.)

-Tolerance

< ±2 % overall (combination Line, load, time and temperature related changes)

Initial Voltage Setting

24.5 V ± 1%

-Ripple 5

< 50 mVpp

PARD

PARD (Periodic and Random Deviation) = 100 mV peak-peak max

Overvoltage Protection

> 30.5 but < 33 Vdc, auto recovery

Power Back Immunity

< 35 V

Nominal Current

5 A (120 W)

10 A (240 W)

-Peak Current 6

1.5 × Nominal Current for 4 seconds minimum while holding voltage > 20 Vdc

-Short Circuit Current

1.5 x Nominal Current at near zero volts at short circuit condition

-Current Limit

PowerBoost™

Parallel Operation

Switch selectable single unit or parallel unit operation. Units will not be damaged by parallel operation (regardless of switch position setting).

Holdup Time

>20 ms (Full load, 100 Vac Input @ T

amb=+25°C) to 95% output voltage

Voltage Fall Time

<150 mS from 95% to 10% rated voltage @ full load (T

amb=+25°C)

Line and Load Regulation

< 0.5%

General

EMC:

-Emissions

EN61000-6-2:2001, EN61000-6-3:2001, Class B EN55011, EN55022 Radiated and Conducted including Annex. A, EN61000-3-2

-Immunity

EN61000-6-1:2001, EN61000-6-2:2001, EN61000-4-2 Level 4, EN61000-4-3 Level 3, EN61000-4-6 Level 3, EN61000-4-4 Level 4 input and

level 3 output. EN61000-4-5 Isolation class 4, EN61000-4-11, IEC 61000-4-34 voltage dip immunity standard

Temperature 7

Storage: -40oC to + 85oC, Operation -25oC to +60oC full power, with linear derating to half power from 60 to 70oC (Convection cooling, no

forced air required).

Operation up to 50% load permissible with sideways or front side up mounting orientation.

MTBF 8

> 550,000 hrs

Warranty

5 Year Limited Warranty

General Protection/

Safety

Protected against continuous short -circuit, continuous overload, continuous open circuit.

Protection Class 1 (IEC536), degree of protection IP20 (IEC60529) Safe low voltage: SELV (acc. IEC60950-1)

Status Indicators

Visual: 3 status LEDs (Input, Output, Alarm)

Relay: N.O. contact rated 200ma/50 Vdc

Installation

Fusing -Input

Internally fused

-Output

Outputs are capable of providing high currents for short periods of time for inductive load startup or switching. Fusing may be required for

wire/loads if 2x Nominal O/P current rating cannot be tolerated. Continuous current overload allows for reliable fuse tripping.

Mounting

Simple snap-on to DIN TS35/7.5 or TS35/15 rail system.

Connections

Input: Screw terminals, connector size range: 16-10 AWG (1.5-6 mm2) for solid conductors. Screw torque: 4.4 lb-inch (~ 50 N-cm).

Output: Two terminals per output, connector size range: 16-10 AWG (1.5-6 mm2) for solid conductors. Screw torque: 7 lb-inch (~ 80 N-cm).

Case

Fully enclosed metal housing with fine ventilation grid to keep out small parts.

-Free Space

25 mm above and below, 10 mm left and right, 15 mm in front

H x W x D inches in (mm)

4.85 × 1.97 × 4.36

(123.0 × 50.0 × 110.0)

4.85 × 2.36 × 4.36

(123.0 × 60.0 × 110.0)

Weight lbs (kg)

1.1 (0.50)

1.7 (0.80)

SDN-C Specifications (Single Phase)

1. Not UL listed for DC input.

2. Input current ratings are conservatively specified with low input, worst case

efficiency and power factor.

3. Losses are heat dissipation in watts at full load, nominal input line.

4. 24-28 Vdc adjustable guaranteed at full load.

5. Ripple/noise is stated as typical values when measured with a 20 MHz, bandwidth

scope and 50 Ohm resistor.

6. Peak current is calculated at 24 Volt levels.

7. Contact tech support for operation at -25oC.

8. Demonstrated through extended life test.