| Electronic Components Datasheet Search |
|
MP2615C Datasheet(PDF) 3 Page - Monolithic Power Systems |
|
|
|||||||||||||||||||||||||||||
MP2615C Datasheet(HTML) 3 Page - Monolithic Power Systems |
|
3 / 22 page ![]() MP2615C – 2.1A, 1-CELL OR 2-CELL LI-ION BATTERY CHARGER MP2615C Rev. 1.1 www.MonolithicPower.com 3 6/15/2023 MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited. © 2023 MPS. All Rights Reserved. PIN FUNCTIONS Pin # Name Description 1 SW Switch output. 2 VIN Power supply voltage. 3 VCC Coarse regulator output. Internally generated 4.5V. Bypass VCC with a 1µF capacitor to AGND. VCC can be used as a low-side switch driver and a pull-up bias voltage NTC resistor divider. Do not connect any external load to VCC. 4 CELL Command input for the number of Li-ion cells. Connect this pin to VCC for single-cell applications. Float the CELL pin or short it to AGND for dual-cell applications. 5 SEL Input pin for setting terminal battery voltage. If SEL is pulled low or floating, VBATT is 4.2V/cell. If SEL is pulled high, VBATT is 4.1V/cell. 6 EN On/off control input. This pin is pulled to GND with a 1M Ω internal resistor. It is recommended to connect a 100k Ω resistor in series with the EN pin. 7 N/C No connection. Leave this pin floating. 8 AGND Analog ground. 9 BATT Positive battery terminal. 10 CSP Battery current-sense positive input. Connect a resistor (RS1) between CSP and BATT. 11 CHGOK Charging completion indicator. When this pin goes logic low, the device is charging. The pin becomes an open drain once the charge is completed or suspended. 12 ACOK Valid input supply indicator. A logic low on this pin indicates the presence of a valid input power supply. 13 NTC Thermistor input. Connect a resistor from this pin to the VCC pin. Connect the thermistor from this pin to ground. 14 TMR Internal safety timer control. Connect a capacitor from this node to AGND to set the timer. Disable the timer by connecting this pin directly to AGND. 15 BST Bootstrap pin. Use a capacitor to drive the power switch’s gate above the supply voltage. The capacitor should be connected between the SW and BST pins to form a floating supply across the power switch driver. 16 PGND Power ground. |
|
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |