MAS9560 datasheet(17/25 Pages) MAS

17 / 25 page

17 (25)

DA9560.001

20 January, 2005

1st byte

2nd byte

3rd byte

4th byte

device id

r/w

code

1001 101

1/0

0000 a3 a2 a1 a0

xxxx xxxx

Called as DW when Write

Called as DR when Read

Table 1. I

2C Data Format

◆ SPI Description

Serial Peripheral Interface (SPI) bus is a 4-wire

serial communication interface between a master

and a slave device. SPI bus is selected by setting

MODE pin to low. SCLK pin is clock, XCS pin chip

select, SDI data pin and SDO data out pin. Data

writing is started with pulling device specific XCS

pin low, and first bit (MSB) is written at next SCLK

rising edge.

The first byte defines register address and whether

data will be read or write, see table 2 below. Bit 5:

Read = 1 and Write = 0. Note that incremental

mode stops at address 0x0F to prevent address

overflow and device reset.

The following byte written to SDI is either register

input data (write mode) or it is ignored (read mode).

In the read mode the selected register’s data can

be read from SDO pin at SCLK falling edge. Data

transfer stops with rising XCS pin.

In case XCS pin is held low after two first bytes, the

increment mode is enabled and the following

written/read bytes can be transferred to/from the

next registers. SDO output is at the high impedance

state when MAS9560 is not in read mode.

Bit

Function

R/W

Table 2. SPI first byte

◆ I

2S Description

Inter-IC Sound (I

2S) bus is a 3-wire serial interface

for transmission of 2-channel (stereo) Pulse Code

Modulation digital data for DACs. Data is sent in 2’s

complement format MSB first. The receiver ignores

extra bits from the transmitter, if more than 16 bits

are transmitted. In case byte length is less than 16

bits, data is still 2’s complement and unspecified

bits are set to zero.

Word Select pin (WSI-pin) can be configured in

MAS9560. The default setting is: WSI = ‘0’ when

data for Channel 1 (left channel) is read, and WSI =

‘1’ when Channel 2 (right channel) is read. This can

be changed with POL byte (see register description

for I

2S Interface Control Register – p. 17).

Left justified format varies also depending on the

delay before the first data byte. Default delay is one

clock pulse, but this delay can be configured with

DEL bit.

MAS9560 supports only Left-Justified Format.

MAS9560 Datasheet(PDF) 17 Page - Micro Analog systems

MAS9560 Datasheet(HTML) 17 Page - Micro Analog systems

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25

Datasheet Download

Link URL