L640GU73PI datasheet(33/55 Pages) AMD

33 / 55 page

June 14, 2005

Am29LV641G

ADV ANCE

I N FO RMAT I O N

program or erase operation), and during the sector

erase time-out.

During an Embedded Program or Erase algorithm op-

eration, successive read cycles to any address cause

DQ6 to toggle. The system may use either OE# or

CE# to control the read cycles. When the operation is

complete, DQ6 stops toggling.

After an erase command sequence is written, if all sectors

selected for erasing are protected, DQ6 toggles for approxi-

mately 100 µs, then returns to reading array data. If not all

selected sectors are protected, the Embedded Erase algo-

rithm erases the unprotected sectors, and ignores the se-

lected sectors that are protected.

The system can use DQ6 and DQ2 together to determine

whether a sector is actively erasing or is erase-suspended.

When the device is actively erasing (that is, the Embedded

Erase algorithm is in progress), DQ6 toggles. When the de-

vice enters the Erase Suspend mode, DQ6 stops toggling.

However, the system must also use DQ2 to determine

which sectors are erasing or erase-suspended. Alterna-

tively, the system can use DQ7 (see the subsection on

DQ7: Data# Polling).

If a program address falls within a protected sector,

DQ6 toggles for approximately 1

μs after the program

command sequence is written, then returns to reading

array data.

DQ6 also toggles during the erase-suspend-program

mode, and stops toggling once the Embedded Pro-

gram algorithm is complete.

Table 11 shows the outputs for Toggle Bit I on DQ6.

Figure 7 shows the toggle bit algorithm. Figure 20 in

the “AC Characteristics” section shows the toggle bit

timing diagrams. Figure 21 shows the differences be-

tween DQ2 and DQ6 in graphical form. See also the

subsection on DQ2: Toggle Bit II.

START

Yes

DQ5 = 1?

Yes

Toggle Bit

= Toggle?

Program/Erase

Operation Not

Complete, Write

Reset Command

Program/Erase

Operation Complete

Read DQ7–DQ0

Toggle Bit

= Toggle?

Read DQ7–DQ0

Twice

Read DQ7–DQ0

Figure 7.

Toggle Bit Algorithm

Note: The system should recheck the toggle bit even if DQ5

= “1” because the toggle bit may stop toggling as DQ5

changes to “1.” See the subsections on DQ6 and DQ2 for

more information.

L640GU73PI Datasheet(PDF) 33 Page - Advanced Micro Devices

L640GU73PI Datasheet(HTML) 33 Page - Advanced Micro Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55

Datasheet Download

Link URL