ABE0101/02/04/06

Low EMI Spread Spectrum Multiplier Clock

30332 Esperanza., Rancho Santa Margarita, Ca 92688 Ph: 949-546-8000 Fax: 949-546-8001 www.Abracon.com 03/21/05 Page 2

BLOCK DIAGRAM

PIN DESCRIPTIONS

Name

Number

Type

Description

XIN/FIN

1

I

clock input.

XOUT/SD

2

B

At power-up, this pin is an input pin to select modulation type. After input

sampling, this pin is crystal output. Has internal pull up resistor.

SC0

3

I

Digital control input to select modulation magnitude. Has internal pull-up.

SC1

4

I

Digital control input to select modulation magnitude. Has internal pull-up.

GND

5

P

Ground.

FOUT

6

O

Modulated Clock Frequency Output. The frequency before modulation is

synthesized by multiplying the input frequency by 1X, 2X, 4X, 6X depending on

the part number (ABE0101, 02, 04, 06).

SC2

7

I

Digital control input to select modulation magnitude. Has internal pull-up.

VDD

8

P

Power Supply.

FUNCTIONAL DESCRIPTION

Selectable spread spectrum and modulation magnitudes

The ABE0101/02/04/06 provides selectable spread spectrum modulation type, as well as selectable modulation

magnitude. Selection is made by connecting specific pins to a logical “zero” or “one” according to the output clock

selection table on page 1.

In order to reduce the number of pins on the chip, the ABE0101/02/04/06 uses pin 2 (XOUT/SD) as a bi-directional

pin. The pin serves as modulation type selector input (SD) upon power-up (see output clock selection table on

page 1), and as XOUT crystal connection as soon as the input has been latched.

Pins 3 (SC0), 4 (SC1), and 7 (SC2) are used as inputs to select the spread spectrum modulation magnitude as

shown on the output clock selection table (page 1).

XTAL

OSC

FOUT

XIN/FIN

XOUT

SC(0:2)

PLL

SST

Control

Logic