AD8627AKSZ-R2 datasheet(16/20 Pages) AD

16 / 20 page

AD8625/AD8626/AD8627

Data Sheet

Rev. F | Page 16 of 20

OUTPUT AMPLIFIER FOR DACs

Many system designers use amplifiers as buffers on the output

of amplifiers to increase the DAC’s output driving capability.

The high resolution current output DACs need high precision

amplifiers on their output as current-to-voltage converters

(I/V). Additionally, many DACs operate with a single supply of

5 V. In a single-supply application, selection of a suitable op

amp may be more difficult because the output swing of the

amplifier does not usually include the negative rail, in this case

AGND. This can result in some degradation of the DAC’s

specified performance, unless the application does not use

codes near zero. The selected op amp needs to have very low

offset voltage—for a 14-bit DAC, the DAC LSB is 300 µV with a

5 V reference—to eliminate the need for output offset trims.

Input bias current should also be very low because the bias

current multiplied by the DAC output impedance (about 10 kΩ

in some cases) adds to the zero-code error. Rail-to-rail input and

output performance is desired. For fast settling, the slew rate of

the op amp should not impede the settling time of the DAC.

Output impedance of the DAC is constant and code

independent, but in order to minimize gain errors, the input

impedance of the output amplifier should be as high as possible.

The AD862x, with a very high input impedance, IB of 1 pA,

and a fast slew rate, is an ideal amplifier for these types of

applications. A typical configuration with a popular DAC is

shown in Figure 46. In these situations, the amplifier adds

another time constant to the system, increasing the settling time

of the output. The AD862x, with 5 MHz of BW, helps in

achieving a faster effective settling time of the combined DAC

and amplifier.

In applications with full 4-quadrant multiplying capability or a

bipolar output swing, the circuit in Figure 47 can be used. In

this circuit, the first and second amplifiers provide a total gain

of 2, which increases the output voltage span to 20 V. Biasing

the external amplifier with a 10 V offset from the reference

voltage results in a full 4-quadrant multiplying circuit.

AD5551/AD5552

AD8627

DGND

*AD5552 ONLY

VDD

VREFF*

VREFS*

OUT

SCLK

DIN

AGND

2.5V

UNIPOLAR

OUTPUT

LDAC*

0.1

µF

0.1

µF

SERIAL

INTERFACE

Figure 46. Unipolar Output

ONE CHANNEL

AD5544

1/2

AD8626

DIGITAL INTERFACE CONNECTIONS

OMITTED FOR CLARITY

VSS

AGNDF

AGNDX

VDD

VREFX

RFBX

ADR01

VREF

10V

1/2

AD8626

–13V

+13V

–10V < VOUT < +10V

10k

Ω

10k

Ω

VOUT

Figure 47. 4-Quadrant Multiplying Application Circuit

AD8627AKSZ-R2 Datasheet(PDF) 16 Page - Analog Devices

AD8627AKSZ-R2 Datasheet(HTML) 16 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Datasheet Download

Link URL