M5295AP datasheet(4/13 Pages) RENESAS

4 / 13 page

M5295AL/AP/AFP

REJ03D0780-0200 Rev.2.00 Jun 15, 2007

Page 4 of 12

Operating Description

(2)(3)

(4) (5)

(6)

(7) (8)

(9)(10)(11)

(1)

The VCC rises up to 0.8 V, then RST1 and RST2 generates low output, and rising up to 4.25 V,

charge of C1 begins.

The VCC rises up to 4.7 V, then RST2 generates high.

The voltage at TC pin is 2 V, then

RST2 generates high, when 4 V, C1 is discharged and RST1

generates low.

The voltage at TC pin falls to 2 V, then

RST1 generates high unless normal clock signal is entered

to WD pin,

RST1 repeats this operation.

Before the voltage at TC pin reaches 4 V, if normal clock signal is entered to WD pin, low

RST1 is

canceled.

In the case of entrance of abnormal signal input, as the waveform of TC pin repeats charge and

discharge of

RST1 alternatively from 2 V to 4 V, the RST1 repeats high and low output operation.

The VCC falls to 4.6 V, then RST2 generates low, this detective voltage has a 100 mV hysteresis.

When VCC goes down to 4.25 V(VTH1), the status of TC pin is switched to discharge. When the

potentional at TC pin is detected being VTH3(H) or VTH3(L), the status of RST1 becomes "low".

Terminology

tRST(1):

tWD

tRST(2):

Time required for TC pin potential to rise from 0 V VTH3(L) when VCC is being applied.

Time required for TC pin potential to rise from VTH3(L) to VTH3(H).

Time required for TC pin potential to go down from VTH3(H) to VTH3(L).

VCC

(1):

(2):

(3), (4):

(5):

(6), (7):

(8), (9):

(10):

(11):

VIN

RST1

RST2

VTH3(H)

VTH2(H)

VTH1

VTH2(L)

VTH1

VTH3(L)

tRST(1)

tWD

tRST(2)

Figure 1 Operating Waveform

M5295AP Datasheet(PDF) 4 Page - Renesas Technology Corp

M5295AP Datasheet(HTML) 4 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13

Datasheet Download

Link URL