CAUTION

The maximum junction temperature, TJ(max) listed in the Absolute Maximum Ratings, is an

additional limitation to prevent damage to the device. Do not violate any values listed in the Absolute

Maximum Ratings. These limits are provided to prevent damage to the device.

8.2.1.2 Input Considerations

Input signals must cross Vt-(min) to be considered a logic LOW, and Vt+(max) to be considered a logic HIGH. Do

not exceed the maximum input voltage range found in the Absolute Maximum Ratings .

Unused inputs must be terminated to either VCC or ground. These can be directly terminated if the input is

completely unused, or they can be connected with a pull-up or pull-down resistor if the input is to be used

sometimes, but not always. A pull-up resistor is used for a default state of HIGH, and a pull-down resistor is

used for a default state of LOW. The resistor size is limited by drive current of the controller, leakage current into

the SN74LVC132A, as specified in the Electrical Characteristics , and the desired input transition rate. A 10kΩ

resistor value is often used due to these factors.

The SN74LVC132A has no input signal transition rate requirements because it has Schmitt-trigger inputs.

Another benefit to having Schmitt-trigger inputs is the ability to reject noise. Noise with a large enough amplitude

can still cause issues. To know how much noise is too much, please refer to the ΔVT(min) in the Electrical

Characteristics . This hysteresis value will provide the peak-to-peak limit.

Unlike what happens with standard CMOS inputs, Schmitt-trigger inputs can be held at any valid value without

causing huge increases in power consumption. The typical additional current caused by holding an input at a

value other than VCC or ground is plotted in the Typical Characteristics.

Refer to Feature Description for additional information regarding the inputs for this device.

8.2.1.3 Output Considerations

The positive supply voltage is used to produce the output HIGH voltage. Drawing current from the output will

decrease the output voltage as specified by the VOH specification in the Electrical Characteristics. Similarly, the

ground voltage is used to produce the output LOW voltage. Sinking current into the output will increase the

output voltage as specified by the VOL specification in the Electrical Characteristics.

Unused outputs can be left floating. Do not connect outputs directly to VCC or ground.

Refer to Feature Description for additional information regarding the outputs for this device.

8.2.2 Detailed Design Procedure

1. Add a decoupling capacitor from VCC to GND. The capacitor needs to be placed physically close to the

device and electrically close to both the VCC and GND pins. An example layout is shown in the Figure 8-3.

2. Ensure the capacitive load at the output is ≤ 70pF. This is not a hard limit; however, it will

optimize performance. This can be accomplished by providing short, appropriately sized traces from the

SN74LVC132A to the receiving device.

3. Ensure the resistive load at the output is larger than (VCC / IO(max)) Ω. This will not violate the maximum

output current from the Absolute Maximum Ratings. Most CMOS inputs have a resistive load measured in

megaohms; much larger than the minimum calculated above.

4. Thermal issues are rarely a concern for logic gates, however the power consumption and thermal increase

can be calculated using the steps provided in the application report, CMOS Power Consumption and Cpd

Calculation

www.ti.com

SN74LVC132A

SCLSA12 – MAY 2024

Copyright © 2024 Texas Instruments Incorporated

Submit Document Feedback

13

Product Folder Links: SN74LVC132A