CLS01 datasheet(2/5 Pages) TOSHIBA

2 / 5 page

CLS01

2006-11-13

Marking

Abbreviation Code

Part No.

S01

CLS01

Standard Soldering Pad

Handling Precautions

1) Schottky barrier diodes have reverse current characteristics compared to other diodes. There is a possibility

that SBDs will cause thermal runaway when used under high-temperature or high-voltage conditions. Be sure

to take forward and reverse loss into consideration during design.

2) The absolute maximum ratings denote the absolute maximum ratings, which are rated values that must not be

exceeded during operation, even for an instant. The following are the general derating methods that we

recommend for when designing a circuit incorporating this device.

VRRM: Use this rating with reference to (1) above. VRRM has a temperature coefficient of 0.1%/°C. Take

this temperature coefficient into account when designing a device for operation at low

temperatures.

IF (AV): We recommend that the worst case current be no greater than 80% of the absolute maximum

rating of IF (AV) and that Tj be below 100°C. When using this device, take the margin into

consideration by using an allowable Tamax-IF (AV) curve.

IFSM: This rating specifies the non-repetitive peak current. This applies only to abnormal operation,

which seldom occurs during the lifespan of the device.

Tj:

Derate this rating when using the device in order to ensure high reliability. We recommend that

the device be used at a Tj of below 100°C.

3) Thermal resistance between junction and ambient fluctuates depending on the mounting condition of the

device. When using the device, design the circuit board and soldering land size to match the appropriate

thermal resistance value.

4) Refer to the databook on Rectifiers for further information.

Unit: mm

2.6

1.8

4.8

5.9

CLS01 Datasheet(PDF) 2 Page - Toshiba Semiconductor