Linear Voltage Regulator – 79L05AC

Negative Fixed 5V Voltage Regulator in bare die form



±4% VOUT tolerance



100mA Output Current



Internal thermal overload protection



Internal short circuit current limit

Die Size (Unsawn)

1000 x 940

39 x 37

µm

mils

Minimum Bond Pad Size

110 x 110

4.33 x 4.33

µm

mils

Die Thickness

280 (±20)

11 (±0.8)

µm

mils

Top Metal Composition

Al-Si-Cu 3µm

Back Metal Composition

N/A – Bare Si



Full Military Temperature Range



Positive Voltage complement is 78L05AC

Rev 1.0

01/05/25

Description

Features:

Ordering Information

79L05AC 5V fixed 3-terminal negative voltage

regulator delivers up to 100mA output current & is

equipped with internal limiting + thermal shutdown

features for overload immunity. Implementing this

device at point-of-source removes the complexity of

single point regulation methods + reduces noise. In

replacement of a Zener diode/resistor combination, the

device improves output impedance by x2 order of

magnitude & delivers lower bias current with lower

noise. The 79L05AC can be used with power-pass

elements to make high-current voltage regulators

.

Die Dimensions in µm (mils)

The following part suffixes apply:



No suffix - MIL-STD-883 /2010B Visual Inspection



“H” - MIL-STD-883 /2010B Visual Inspection

+ MIL-PRF-38534 Class H LAT



“K” - MIL-STD-883 /2010A Visual Inspection (Space)

+ MIL-PRF-38534 Class K LAT

LAT = Lot Acceptance Test.

For further information on LAT process flows see below.

www.siliconsupplies.com\quality\bare-die-lot-qualification

Supply Formats:

Mechanical Specification

1000 (39)



Default – Die in Waffle Pack (400 per tray capacity)



Sawn Wafer on Tape – On request



Unsawn Wafer – On request



With Ti/Ni/Ag Back Metal – On request



In Metal or Ceramic package – On request

Page 1 of 4

www.siliconsupplies.com