©

National Instruments Corporation

5

CB-100 I/O Connector Block Installation Guide

•

For rail mounting, pry off the right and left ends of the connector

block with a screwdriver as shown in Figure 5.

Figure 5. Removing the Connector Block Ends

Insert the rail-mount bracket into the slots on the bottom of the

connector block as shown in Figure 6.

Figure 6. Inserting the Rail-Mount Bracket

Replace the end of the connector block and push very firmly until

it snaps into place. Repeat for the other side, making sure that both

rail-mount brackets are facing the same direction.

Slide the rail-mount brackets of the connector block onto your

rails.

Rail-Mount Bracket