Features

•

L6362A

IO-Link device transceiver main characteristics:

–

IO-Link PHY layer

–

Dedicated overload diagnostic

s pin

–

UART interface

–

Selectable 12 mA 3.3 V or 10 mA 5.0 V linear regulator

–

Overload and overheating protections with non-dissipative cut-off function

–

Full reverse polarity on IO-Link interface pins

–

EMC protections (as per IO-Link v1.1)

–

Surge protection (as per IEC 60947-5-2)

–

DFN-12L (3x3x0.9 mm) package

•

6.5 to 35 V operating voltage range

•

On-board 100 mA 12 V linear regulator

(L78L)

•

LEDs for status and diagnostics

•

Ground and VCC wire break protections

•

Compatible with STM32 Nucleo boards

•

Equipped with Arduino UNO R3 connectors

•

RoHS and China RoHS compliant

Description

The STEVAL-IOD003V1 evaluation board is based on the L6362A IO-Link PHY

device with full integrated EMC protection (according to IO-Link v1.1 specification)

and surge protection (according to IEC 60947-5-2). It provides an affordable and

easy-to-use solution for the development of IO-Link and SIO applications, letting you

easily evaluate the communication features and robustness of the L6362A.

The on-board linear regulators (

12 mA-3.3 V from L6362A and 100 mA-12 V from

L78L12ABUTR) can be used to supply the microcontroller via the 24 V bus, instead

of via USB.

When the L78L12ABUTR is enabled (default configuration), you can also perform

evaluation of complete industrial sensor modules by connecting the STEVAL-

IOD003V1 to a NUCLEO-L073RZ (or NUCLEO-L053R8) board and an X-NUCLEO-

IKS01A2 expansion board.

The STEVAL-IOD003V1 interfaces with the STM32 controller via UART and GPIO

pins and is compatible with the Arduino UNO R3 (default configuration) and ST

morpho (optional, not mounted) connectors.

Product summary

IO-Link device

evaluation board

based on L6362A

with Arduino

connectors for

STM32 Nucleo

STEVAL-IOD003V1

IO-Link

communication

transceiver

device IC

L6362A

L6362A IO-Link

communication

transceiver

device IC

evaluation

software based

on STM32Cube

STSW-IOD003

IO-Link

(PHY) device evaluation board based on L6362A with Arduino

connectors for STM32 Nucleo

STEVAL-IOD003V1

Data brief

DB3634 - Rev 1 - June 2018

For further information contact your local STMicroelectronics sales office.

www.st.com