SLAS787 datasheet(42/52 Pages) TI2

42 / 52 page

MSP430G2231-Q1

SLAS787B – NOVEMBER 2011 – REVISED MARCH 2014

www.ti.com

11.1.1.3.3

Command-Line Programmer

MSP430 Flasher is an open-source, shell-based interface for programming MSP430 microcontrollers through a

FET programmer or eZ430 using JTAG or Spy-Bi-Wire (SBW) communication. MSP430 Flasher can be used to

download binary files (.txt or .hex) files directly to the MSP430 Flash without the need for an IDE.

11.1.1.4 Community Resources

The following links connect to TI community resources. Linked contents are provided "AS IS" by the respective

contributors. They do not constitute TI specifications and do not necessarily reflect TI's views; see TI's Terms of

Use.

TI E2E Community

TI's Engineer-to-Engineer (E2E) Community. Created to foster collaboration among engineers. At e2e.ti.com, you

can ask questions, share knowledge, explore ideas, and help solve problems with fellow engineers.

TI Embedded Processors Wiki

Texas Instruments Embedded Processors Wiki. Established to help developers get started with embedded

processors from Texas Instruments and to foster innovation and growth of general knowledge about the

hardware and software surrounding these devices.

11.1.2 Device and Development Tool Nomenclature

To designate the stages in the product development cycle, TI assigns prefixes to the part numbers of all

MSP430™ MCU devices and support tools. Each MSP430™ MCU commercial family member has one of three

prefixes: MSP, PMS, or XMS (for example, MSP430F5259). Texas Instruments recommends two of three

possible prefix designators for its support tools: MSP and MSPX. These prefixes represent evolutionary stages of

product development from engineering prototypes (with XMS for devices and MSPX for tools) through fully

qualified production devices and tools (with MSP for devices and MSP for tools).

Device development evolutionary flow:

XMS – Experimental device that is not necessarily representative of the final device's electrical specifications

PMS – Final silicon die that conforms to the device's electrical specifications but has not completed quality and

reliability verification

MSP – Fully qualified production device

Support tool development evolutionary flow:

MSPX – Development-support product that has not yet completed Texas Instruments internal qualification

testing.

MSP – Fully-qualified development-support product

XMS and PMS devices and MSPX development-support tools are shipped against the following disclaimer:

"Developmental product is intended for internal evaluation purposes."

MSP devices and MSP development-support tools have been characterized fully, and the quality and reliability of

the device have been demonstrated fully. TI's standard warranty applies.

Predictions show that prototype devices (XMS and PMS) have a greater failure rate than the standard production

devices. Texas Instruments recommends that these devices not be used in any production system because their

expected end-use failure rate still is undefined. Only qualified production devices are to be used.

TI device nomenclature also includes a suffix with the device family name. This suffix indicates the package type

(for example, PZP) and temperature range (for example, T). Figure 17 provides a legend for reading the

complete device name for any family member.

Submit Documentation Feedback

Product Folder Links: MSP430G2231-Q1

SLAS787 Datasheet(PDF) 42 Page - Texas Instruments

SLAS787 Datasheet(HTML) 42 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52

Datasheet Download

Link URL