7.3.3 Using the Output Difference Amplifier to Shape Noise

The functional block diagram in Section 7.2 shows that the PGA848 output-stage difference amplifier uses a

6.67kΩ feedback resistor between the output and the inverting input. External direct access to the inverting and

noninverting inputs of the difference amplifier is provided through the DA_IN– and DA_IN+ pins, respectively.

This option allows circuit designers to add external capacitors in parallel with the internal resistors to implement

noise-filtering or noise-shaping techniques. These pins are also used to implement customized attenuating gains

for the output stage. Consider the following important factors when designing parallel circuits with the internal

resistors:

• The accuracy of the internal resistor network is 0.01% or better. This accuracy results in a common-mode

rejection (CMRR) of 80dB or better. Mismatched leakage currents on these pins potentially cause CMRR

degradation.

• The internal resistors have ±15% absolute resistance variation. Consider this variation when implementing

custom attenuating gains or noise filters.

CAUTION

Do not treat these pins as outputs, nor use the pins to source or sink current. Excessive currents

through the feedback resistors potentially cause permanent damage to internal circuitry.

7.4 Device Functional Modes

The PGA848 has a single functional mode. The device operates when the input-stage power supply is greater

than ±4.5V (9V) and the output stage power supply is greater than ±2.25V (4.5V). Additionally, see Section 6.3.

PGA848

SBOSAN4 – AUGUST 2025

www.ti.com

12

Submit Document Feedback

Copyright © 2025 Texas Instruments Incorporated

Product Folder Links: PGA848