114-20040

Rev.A3

3 of 4

3.4 Insulation barrel crimp

A. Crimp dimensions and type

Crimp width and type shall be as shown in Figure 5.

B. Workmanship

Reasonable care shall be taken not to cut or break the insulation during the crimping operation.

3.5 Locking lance

Locking lance shall not be deformed.

3.6 Alignment

A. Straightness

1. The contact, including the cutoff tab and burr shall not be bent below the datum line or more than .020

above the datum line, as shown in Figure 3.

FIGURE 3

2. The side to side bending of the contact shall not exceed the limits specified in Figure 4.

.105

FIGURE 4

B. Twist or roll

There shall be no twist or roll in crimped portion that will impair usage of the contact.

Datum line

.020 Max